Saab
1994 900
- 12
- trims
Gallery
OEM press photography
The market
Open in QuoteMedian ask
—
- —
- best
- —
- avg days listed
- —
- cuts · 30d
Trims & pricing
Shop listings| Trim | MSRP | Live | Trades at | Premium | Instrument |
|---|---|---|---|---|---|
| Base Turbo 2dr Convertible | — | — | — | — | — |
| 2.0 16V Turbo (185 Hp) 2.0 16V Turbo (185 Hp) | — | — | — | — | — |
| Commemorative Commemorative Turbo 2dr Convertible | — | — | — | — | — |
| S S 2dr Hatchback | — | — | — | — | — |
| 2.0i 16V (126 Hp) 2.0i 16V (126 Hp) | — | — | — | — | — |
| 2.3 16V (150 Hp) 2.3 16V (150 Hp) | — | — | — | — | — |
| SE SE Turbo 2dr Hatchback | — | — | — | — | — |
| 2.0i (131 Hp) 2.0i (131 Hp) | — | — | — | — | — |
| 2.5 V6 24V (170 Hp) 2.5 V6 24V (170 Hp) | — | — | — | — | — |
| 2.0 Turbo 16V (180 Hp) 2.0 Turbo 16V (180 Hp) | — | — | — | — | — |
| 2.0i 16V (126 Hp) Automatic 2.0i 16V (126 Hp) Automatic | — | — | — | — | — |
| SE V6 SE V6 4dr Hatchback | — | — | — | — | — |
Safety & recalls
Full recall reportTHESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 108 - LIGHTING SYSTEM AND RETROREFLECTIVE DEVICES. THE SECTION TITLED "HEADLAMP AIMING" WAS OMITTED FROM THE OWNER'S MANUAL. CORRECTION: DEALERS WILL INSERT A PAGE SUPPLEMENT IN THE OWNER'S MANUAL CONTAINING THE INSTRUCTIONS ON HEADLAMP AIMING.
1998163 · 4,340 units in campaign · Transport Canada
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE INSTRUCTIONS FOR PROPERLY AIMING THE HEADLIGHTING SYSTEM WERE OMITTED. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."
Potential consequence
IF THE HEADLAMP ASSEMBLIES ARE REPLACED, CUSTOMERS MAY NOT BE ABLE TO PROPERLY AIM THE HEADLIGHTS.
Remedy
OWNERS WILL BE SENT AIMING INSTRUCTIONS, AND DIRECTIONS FOR AFFIXING THESE INSERTS TO THE OWNER GUIDES. IF AN OWNER SO DESIRES, A DEALER CAN AFFIX THE INSERTS IN THEIR OWNER GUIDE FOR THEM.
98V038000 · 92,505 units in campaign · NHTSA
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
NOTE: VEHICLES WITH 4-CYLINDER ENGINES. THE ZINC-COATED THROTTLE CONTROL LEVER BUSHINGS IN THE THROTTLE HOUSING MAY CORRODE, CAUSING THE THROTTLE LEVER TO BIND. THIS COULD RESULT IN THE THROTTLE PLATE NOT RETURNING TO THE CLOSED POSITION WHEN THE ACCELERATOR PEDAL IS RELEASED AND A SUBSEQUENT LOSS OF THROTTLE CONTROL. CORRECTION: ZINC-COATED THROTTLE LEVER BUSHING IN THE THROTTLE HOUSING WILL BE REPLACED WITH A NICKEL-COATED BUSHING AND BOLT.
1997099 · 2,454 units in campaign · Transport Canada
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
CORROSION AROUND THE ZINC-COATED THROTTLE CONTROL LEVER BUSHING CAN CAUSE THE THROTTLE LEVER TO BIND.
Potential consequence
THIS BINDING CAN RESULT IN THE THROTTLE PLATE NOT RETURNING TO THE CLOSED POSITION WHEN THE THROTTLE PEDAL IS RELEASED AND A SUBSEQUENT LOSS OF THROTTLE CONTROL.
Remedy
DEALERS WILL REPLACE THE ZINC-COATED THROTTLE CONTROL LEVER BUSHING WITH A NICKEL-COATED BUSHING AND BOLT.
97V046000 · 52,500 units in campaign · NHTSA
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
NOTE: VEHICLES EQUIPPED WITH MANUAL TRANSMISSION INCLUDES 1995 SAAB 900 CONVERTIBLES. DEFECT: IT IS POSSIBLE UNDER CERTAIN PARKING CONDITIONS TO MOVE THE SHIFT LEVER INTO THE REVERSE GEAR POSITION, REMOVE THE IGNITION KEY, AND STILL HAVE THE TRANSMISSION IN NEUTRAL, OR, TO ACCIDENTALLY DISENGAGE REVERSE BY STRIKING THE SHIFT LEVER. IF THE HAND BRAKE IS NOT APPLIED, IT IS POSSIBLE TO HAVE THE CAR ROLL FROM ITS ORIGINAL PARKED POSITION. CORRECTION: TWO WASHERS WILL BE REPLACED AND THE SHIFT LINKAGE WILL BE ADJUSTED.
1995136 · 575 units in campaign · Transport Canada
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
IT IS POSSIBLE TO MOVE THE SHIFT LEVER INTO THE REVERSE GEAR POSITION, REMOVE THE IGNITION KEY, AND STILL HAVE THE TRANSMISSION IN NEUTRAL, OR, TO ACCIDENTLY DISENGAGE REVERSE BY STRIKING THE GEAR LEVER.
Potential consequence
IF THE PARKING BRAKE IS NOT APPLIED, THE CAR CAN ROLL FROM ITS ORIGINAL PARKED POSITION INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.
Remedy
DEALERS WILL REPLACE TRANSMISSION LINKAGE COMPONENTS AND COMPLETE A SPECIALLY DEVELOPED SERVICE ADJUSTMENT PROCEDURE THAT WILL ENSURE THAT WHEN THE SHIFT IS MOVED TO THE REVERSE POSITION, THE REVERSE GEAR IS ACTUALLY ENGAGED.
95V068000 · 8,993 units in campaign · NHTSA
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
NOTE: 1994-95 3 AND 5 DOOR MODELS AND 1995 CONVERTIBLES. THE SEAT ASSEMBLIES MAY BE MISSING ONE OR MORE OF THE ARC WELDS THAT JOIN THE SEAT BACK RECLINER MECHANISM TO THE SEAT BACK FRAME. THIS COULD RESULT IN THE SEAT BACK FALLING BACKWARDS IF THE VEHICLE IS IMPACTED FROM THE REAR. SUDDEN FAILURE OF A DRIVER SEAT BACK COULD OCCUR WITHOUT PRIOR WARNING AND CAUSE THE DRIVER TO LOSE CONTROL, RESULTING IN A POSSIBLE CRASH. CORRECTION: SEAT BACKS WILL BE INSPECTED AND REPLACED IF REQUIRED.
1995028 · 671 units in campaign · Transport Canada
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
ONE OR MORE OF THE ARC WELDS CAN BE MISSING ON THE SEAT BACK FRAME RECLINER.
Potential consequence
THIS CAN RESULT IN A SEAT BACK FALLING BACKWARDS UNDER A LOAD.
Remedy
BOTH FRONT SEAT BACKS WILL BE INSPECTED WITH THE USE OF A HOOK TO PULL BACK THE SEAT BACK UPHOLSTERY. FOR ANY SEAT WITH MISSING WELDS, THE SEAT BACK FRAME/RECLINER WILL BE REPLACED.
94V226000 · 10,584 units in campaign · NHTSA
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
THE TWO WELD POINTS IN THE REARWARD ATTACHMENT BRACKET FOR THE SIDE IMPACT PROTECTION BEAM IN THE REAR DOOR MAY BE OUT OF POSITION. IF THE WELDS ARE OUT OF POSITION, THE VEHICLES WILL NOT MEET THE REQUIREMENTS OF FMVSS 214, S5, "SIDE DOOR STRENGTH."
Potential consequence
CONSEQUENCE OF NON-COMPLIANCE: PASSENGERS SITTING IN THE REAR SEATS WILL BE SUBJECT TO AN INCREASED RISK OF INJURY IN THE EVENT OF A SIDE COLLISION.
Remedy
DEALERS WILL INSTALL SUPPORT BRACKETS AT THE SUPPORT WELD LOCATIONS.
94V174000 · 9,814 units in campaign · NHTSA
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
On certain vehicles equipped with manually adjusted front seats, it is possible that the two (2) trigger springs mounted to the fore/aft adjustment lever on both front seats cannot develop sufficient force to properly lock the seat rails. This could result in the seat moving in the event of a collision. Correction: faulty springs will be replaced with ones with the appropriate trigger spring force.
1994127 · 69 units in campaign · Transport Canada
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
THERE IS A RISK OF FATIGUE CRACKS AROUND THE ATTACHMENT BUSHINGS ON THE HEIGHT ADJUSTING MECHANISM IN THE DRIVER'S SEAT. IN THE EVENT OF A REAR END COLLISION, THE HEIGHT ADJUSTER COULD BREAK AND ALLOW THE SEAT TO FOLD DOWN REARWARD. CORRECTION: DEALERS WILL REPLACE THE SEAT RAILS, ON THE DRIVER'S SIDE, WITH NEW ONES.
1994121 · 187 units in campaign · Transport Canada
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
TWO TRIGGER SPRINGS MOUNTED TO THE FORE/AFT ADJUSTMENT LEVER DO NOT DEVELOP SUFFICIENT FORCE TO PROPERLY LOCK THE SEAT RAILS. AFTER THE SEAT IS ADJUSTED, THIS DOES NOT ALLOW THE SEAT RAIL LOCK TO PROPERLY ENGAGE, WHICH CAN CAUSE THE SEAT TO MOVE IN A SUDDEN STOP OR COLLISION.
Potential consequence
THIS CAN INCREASE THE POSSIBILITY OF INJURY TO A SEAT OCCUPANT IN THE EVENT OF A SUDDEN STOP OR ACCIDENT.
Remedy
DEALERS WILL REMOVE BOTH FRONT SEATS AND THE TWO SPRINGS ON EACH SEAT WILL BE REPLACED WITH NEW SPRINGS WITH PROPER TENSION TO ENSURE PROPER ENGAGEMENT.
94V127000 · 1,015 units in campaign · NHTSA
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
A WELD IN THE SEAT RAILS WAS NOT MADE, INCREASING THE RISK OF FATIGUE CRACKS FORMING AROUND THE ATTACHMENT BUSHINGS ON THE HEIGHT ADJUSTMENT MECHANISM, CAUSING THE POSSIBILITY OF THE HEIGHT ADJUSTER BREAKING IN A REAR END COLLISION AND ALLOWING THE SEAT TO FOLD BACKWARDS.
Potential consequence
THIS CAN INCREASE THE RISK OF INJURY TO SEAT OCCUPANTS.
Remedy
DEALERS WILL INSTALL NEW FRONT SEAT FRAME RAILS.
94V110000 · 3,252 units in campaign · NHTSA
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
THE FRONT BRAKE DISCS AND/OR PADS CAN BE COATED WITH A LAYER OF SLUSH, ROAD SALT OR WATER WHILE DRIVING IN SNOW OR HEAVY RAIN. THIS CAN RESULT IN A SHORT DELAY IN BRAKING ACTION THAT INCREASES THE NORMAL BRAKING DISTANCE. CORRECTION: THE FRONT BRAKE SHIELDS WILL BE REPLACED WITH ONES OF A NEW DESIGN TO IMPROVE THE PROTECTION OF THE INNER BRAKE PADS AND DISCS.
1994105 · 405 units in campaign · Transport Canada
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
THE ORIGINAL FRONT BRAKE DISCS AND/OR PADS SHIELDS DO NOT PROTECT THE ASSEMBLIES FROM BEING COATED WITH A LAYER OF SLUSH, ROAD SALT OR WATER WHILE DRIVING IN SNOW OR HEAVY RAIN. THIS CAN RESULT IN A DELAY IN BRAKING ACTION THAT INCREASES NORMAL STOPPING DISTANCE.
Potential consequence
INCREASED STOPPING DISTANCE COULD RESULT IN AN ACCIDENT.
Remedy
DEALERS WILL REPLACE THE ORIGINAL FRONT BRAKE SHIELDS WITH A NEW DESIGN. AN ADDITIONAL HOLE WILL BE DRILLED IN THE STEERING KING PIN HOUSING TO ATTACH A LARGER COVER PLATE. A SMALLER PROTECTION PLATE WILL ALSO BE ATTACHED TO THE EXISTING TWO BOLTS IN THE HUB.
94V074000 · 7,443 units in campaign · NHTSA
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
Keep going
elsewhere in CardogListingsEvery live 1994 900 on the market, filterable by trim, price, and distance.Recall reportRecalls listed for this model year, with defect, risk, and remedy, and the manufacturer's VIN lookup to confirm.15 campaignsQuoteThe instrument view — price history, market depth, and trim-level comparisons.