Gmc
Canyon

I've noticed an issue since I picked up my vehicle from its last service where the RPMs stay around 1,000 when I let off the gas and should be coasting. The vehicle will continue to accelerate at 11 to 13 mph, and I really have to mash the brake pedal to stop. There is an update notice that popped up starting yesterday, but it will not install. Looks like the update is for the issue I am having. The update was supposed to be installed already per the service bulletin. Update number is N242452130

The contact owns a 2024 GMC Canyon. The contact stated that while driving at various speeds, the steering wheel was rattling abnormally. The check engine warning light was briefly illuminated. The vehicle was taken to a local dealer, where the vehicle was test-driven; however, the failure was not identified. The failure reoccurred, and the vehicle was taken back to the same local dealer, where it was diagnosed as needing a rear intermediate steering shaft, and a retest was performed. The vehicle was repaired; however, the failure reoccurred. The vehicle was taken back to the same local dealer, where the vehicle remained under investigation. The manufacturer was made aware of the failure. The failure mileage was approximately 4,491.

2024 GMC Canyon Elevation trim 4x4 with 31,000 miles on it always had maintenance every 5k interval. I noticed an upper radiator hose leak significant enough to require a decent amount of coolant and decided to take it in to GMC to get it repaired. Mind you this repair is almost $1,000 to get repaired with the hose itself only costing $148. It's disappointing to have such a new truck and have these kinds of problems and upon research there seems to be several others with the same problem relating to an O ring in the upper radiator hose. Considering the truck is routinely serviced more frequently than required I see this as an issue for someone to run out of coolant and possibly be stranded on the side of the road if gone unnoticed and needs to be properly addressed asap.

16,000 miles driven and my replace brake sensor light came on the dashboard. I took it in to get looked at and was told the Front Drivers Side has 1 brake pad showing a life of 5 while my other pads all showed a life of 9/10. I was told that most likely something stuck inside the brake pad itself causing it to wear unevenly but I don't drive anything but highway and paved roads. I looked around other forums and multiple others are complaining of the same issue. I contacted GM and they told me brakes are a wear item. The dealer told me they aren't sure how it happened, but this isn't right to be replacing brakes on a brand new vehicle I've only driven for 10 months. Multiple others are saying the same thing in GM/Colorado forums.

Break monitors for front breaks have dislodged and caused damage to rotors and pads. Dealer claims this is normal wear! Breaks shimmy when breaking in all directions and squeak when backing. I travel to my work requiring mountain passes during inclement weather. The most important safety method while traveling on snow and ice is smooth steering, acceleration and breaking. With my font breaks shimmying, I am concerned for my safe control of the vehicle. Thank you in advance for your attention to this matter.

Infotainment system audio not working. Have performed hard reset, dealer reset, dealer service, and still audio is intermintant at best. more than 75% of the time I have no audio or sound at all. No raidio, no sxm, no bluetooth, no onstar. This is a safety issue and there does not appear to be a repair bulletin, and dealships dont know what to do.

The contact owns a 2024 GMC Canyon. The contact stated that on several occasions while driving at an undisclosed speed under sunny conditions, light entering through the windshield reflected off the chrome trim around the instrument panel and caused distortion and lines in the driver's side and driver’s mirror, creating a visibility hazard. The contact added that the glare disappeared when the windows were rolled down. The vehicle was taken to a dealer, and the contact was informed that the vehicle was operating normally. The manufacturer was notified of the failure. The failure mileage was 12,604.

Vehicle brakes stopped working while driving. Dash board lit up and stated system brake failure. Also stated “do not exceed 43mph”