2008 Mazda Tribute
Safety Recalls & Notices
We found 10 safety recalls for the 2008 Mazda Tribute. Recalls are sourced from both NHTSA (US) and Transport Canada databases. Contact your authorized Mazda dealer to schedule free repairs.
Summary
A safety defect may exist in vehicles in which remanufactured automatic transmissions were installed as service replacement parts. The shift lever bolt may not have been torqued to the proper torque specification. If the improperly torqued shift level bolt loosens and backs out, the shift lever may disengage from the transmission without warning, and the transmission may not respond to the shifter selection movement by the operator. This could result in the loss of transmission gear selection, and possible unintended vehicle movement, which would increase the risk of a crash causing injury and/or property damage. Correction: Dealers will inspect, and if necessary, replace the shift lever assembly and/or the shift level bolt torqued to the proper specification.
Summary
On certain vehicles, a fault in the Electric Power Steering (EPS) system could result in an immediate loss of power steering assist without warning to the driver. This would unexpectedly increase the steering effort force necessary to steer the vehicle at lower vehicle speeds, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will affect repairs as necessary and will reprogram the EPS controller with updated software. In the event that an EPS fault occurs, this updated software would allow for continued EPS function while displaying visual and audible warnings to the driver until the end of the drive cycle.
Summary
On certain vehicles equipped with a 3.0L V6 engine and speed control, inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. A stuck throttle may result in very high vehicle speeds and make it difficult to slow or stop the vehicle if the transmission is not shifted into neutral. This could result in a crash causing property damage and/or personal injury. Correction: Dealers will replace the rear engine cover fastener, which will raise the cover in the area of the speed control cable to provide adequate clearance between the cover the speed control cable connector.
Summary
Mazda North American Operations (Mazda) is recalling certain model year 2008 Tribute vehicles manufactured February 9, 2007 to April 22, 2008. The affected vehicles have had their CD4E transmission replaced with remanufactured one that was rebuilt between June 11, 2015 through July 15, 2015. These service repair part transmissions have a shift lever bolt that may not be properly tightened. As a result, the shift control lever could disengage from the transmission without warning.
Potential Consequence
If the shift lever disengages from the transmission, a driver may be unable to shift gear positions and the indicated shift position may not represent the gear position the vehicle is in. Should a disengagement occur while the vehicle is being driven, when the driver goes to stop and park the vehicle, the gear selection indicator may show that the transmission is in the "PARK" position, but the vehicle transmission may not actually be in the "PARK" gear position. If the vehicle is not in the "PARK" position there is a risk the vehicle will roll away as the driver and other occupants exit the vehicle or anytime thereafter. A vehicle rollaway increases the risk of injury to exiting occupants and bystanders.
Remedy
Mazda will notify owners, and dealers will inspect the transmission and if necessary tighten the manual shift lever bolt or replace the manual shift lever assembly, free of charge. The recall began on November 30, 2015. Owners may contact Mazda Customer Experience Center at 1-800-222-5500, option#6. Mazda's number for this recall is 8815J.
Summary
Mazda North American Operations (Mazda) is recalling certain model year 2008 Tribute vehicles manufactured February 9, 2007 to April 22, 2008. The affected vehicles have had their CD4E transmission replaced with remanufactured one that was rebuilt between June 11, 2015 through July 15, 2015. These service repair part transmissions have a shift lever bolt that may not be properly tightened. As a result, the shift control lever could disengage from the transmission without warning.
Potential Consequence
If the shift lever disengages from the transmission, a driver may be unable to shift gear positions and the indicated shift position may not represent the gear position the vehicle is in. Should a disengagement occur while the vehicle is being driven, when the driver goes to stop and park the vehicle, the gear selection indicator may show that the transmission is in the "PARK" position, but the vehicle transmission may not actually be in the "PARK" gear position. If the vehicle is not in the "PARK" position there is a risk the vehicle will roll away as the driver and other occupants exit the vehicle or anytime thereafter. A vehicle rollaway increases the risk of injury to exiting occupants and bystanders.
Remedy
Mazda will notify owners, and dealers will inspect the transmission and if necessary tighten the manual shift lever bolt or replace the manual shift lever assembly, free of charge. The recall began on November 30, 2015. Owners may contact Mazda Customer Experience Center at 1-800-222-5500, option#6. Mazda's number for this recall is 8815J.
Summary
The Timken Company (Timken) is recalling certain aftermarket front wheel bearings, part number 510072, sold from January 22, 2015, to May 21, 2015, to be used as service parts on 2001-2012 Ford Escape, 2001-2011 Mazda Tribute, and 2005-2011 Mercury Mariner vehicles. The affected wheel bearings have incorrect dimensions of a 42mm bore, 76mm outer dimension, and 39mm width, instead of a 42mm bore, 78mm outer dimension and a 45mm width.
Potential Consequence
Use of an incorrectly sized wheel bearing can adversely affect the braking and steering of the vehicle, increasing the risk of a crash.
Remedy
Timken has begun notifying distributors who will offer purchasers replacement wheel bearings, free of charge. The recall began on May 21, 2015. Owners may contact Timken customer service at 1-866-984-6536.
Summary
Mazda North American Operations (Mazda) is recalling certain model year 2008 Mazda Tribute Hybrid vehicles manufactured October 10, 2006, to May 23, 2008. The coolant pump for the hybrid system may fail, resulting in the hybrid electronics overheating.
Potential Consequence
If the hybrid electronics system overheats, it may shut down the powertrain, resulting in a stall-like condition, increasing the risk of a crash.
Remedy
Mazda will notify owners, and dealers will replace the original Motor Electronics Coolant (MEC) Pump with an improved brushless pump, free of charge. The recall began November 5, 2014. Owners may contact Mazda customer service at 1-800-222-5500. Mazda's number for this recall is 7814I.
Summary
Mazda North American Operations (Mazda) is recalling certain model year 2008-2011 Tribute vehicles manufactured October 5, 2006, through September 11, 2010. The affected vehicles have a steering torque sensor that may not be able to properly detect driver steering input. As a result, the system could remove the Electric Power Steering (EPS) assist.
Potential Consequence
If power steering assist is lost, greater driver effort would be required to steer the vehicle at low speeds, increasing the risk of a crash.
Remedy
Mazda will notify owners and dealers will update the software for the power steering control module (PSCM) and the instrument cluster module, free of charge. If a vehicle shows a history of a loss of the torque sensor signal or fault codes relating to the PSCM when the vehicle is brought in for the recall remedy, the affected components will be replaced, free of charge. The recall began in July 2014. Owners may contact Mazda customer service at 1-800-222-5500. Mazda's number for this recall is 7614E.
Summary
Mazda is recalling certain model year 2001 through 2006, and 2008, Tribute vehicles equipped with 3.0L V6 engines and speed control. Inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. This risk exists regardless of whether or not speed control (cruise control) is used.
Potential Consequence
A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could cause a crash, serious injury or death.
Remedy
Mazda will notify owners, and dealers will repair the vehicles by increasing the engine cover clearance, free of charge. Remedy parts are now available. The safety recall began on September 13, 2012. Owners may contact Mazda Customer Assistance Center at 1-800-222-5500, option #6.
Summary
Mazda is recalling certain model year 2001 through 2006, and 2008, Tribute vehicles equipped with 3.0L V6 engines and speed control. Inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. This risk exists regardless of whether or not speed control (cruise control) is used.
Potential Consequence
A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could cause a crash, serious injury or death.
Remedy
Mazda will notify owners, and dealers will repair the vehicles by increasing the engine cover clearance, free of charge. Remedy parts are now available. The safety recall began on September 13, 2012. Owners may contact Mazda Customer Assistance Center at 1-800-222-5500, option #6.
10 Active Recalls
Requires attention
2008 Mazda Tribute Recall FAQs
Common questions about recalls for this vehicle
Related Recall Checks
Compare recall history with competitors and alternatives to the 2008 Mazda Tribute.