2005 Mazda Tribute
Safety Recalls & Notices
7 Active Recalls
Requires attention
SUSPENSION:FRONT:WHEEL BEARING
Summary
The Timken Company (Timken) is recalling certain aftermarket front wheel bearings, part number 510072, sold from January 22, 2015, to May 21, 2015, to be used as service parts on 2001-2012 Ford Escape, 2001-2011 Mazda Tribute, and 2005-2011 Mercury Mariner vehicles. The affected wheel bearings have incorrect dimensions of a 42mm bore, 76mm outer dimension, and 39mm width, instead of a 42mm bore, 78mm outer dimension and a 45mm width.
Potential Consequence
Use of an incorrectly sized wheel bearing can adversely affect the braking and steering of the vehicle, increasing the risk of a crash.
Remedy
Timken has begun notifying distributors who will offer purchasers replacement wheel bearings, free of charge. The recall began on May 21, 2015. Owners may contact Timken customer service at 1-866-984-6536.
Other
Summary
On certain vehicles equipped with a 3.0L V6 engine and speed control, inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. A stuck throttle may result in very high vehicle speeds and make it difficult to slow or stop the vehicle if the transmission is not shifted into neutral. This could result in a crash causing property damage and/or personal injury. Correction: Dealers will replace the rear engine cover fastener, which will raise the cover in the area of the speed control cable to provide adequate clearance between the cover the speed control cable connector.
ENGINE AND ENGINE COOLING
Summary
Mazda is recalling certain model year 2001 through 2006, and 2008, Tribute vehicles equipped with 3.0L V6 engines and speed control. Inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. This risk exists regardless of whether or not speed control (cruise control) is used.
Potential Consequence
A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could cause a crash, serious injury or death.
Remedy
Mazda will notify owners, and dealers will repair the vehicles by increasing the engine cover clearance, free of charge. Remedy parts are now available. The safety recall began on September 13, 2012. Owners may contact Mazda Customer Assistance Center at 1-800-222-5500, option #6.
VEHICLE SPEED CONTROL:CABLES
Summary
Mazda is recalling certain model year 2001 through 2006, and 2008, Tribute vehicles equipped with 3.0L V6 engines and speed control. Inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. This risk exists regardless of whether or not speed control (cruise control) is used.
Potential Consequence
A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could cause a crash, serious injury or death.
Remedy
Mazda will notify owners, and dealers will repair the vehicles by increasing the engine cover clearance, free of charge. Remedy parts are now available. The safety recall began on September 13, 2012. Owners may contact Mazda Customer Assistance Center at 1-800-222-5500, option #6.
SEATS:FRONT ASSEMBLY:HEAD RESTRAINT
Summary
CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITHOUT SIDE AIR CURTAINS OR MOON ROOFS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACT." DURING TESTING, THE FREE MOTION HEAD FORM REGISTERED A MEASUREMENT ABOVE THE PERMITTED LIMIT AT THE LEFT HAND A-PILLAR TRIM AREA.
Potential Consequence
IN THE EVENT OF A VEHICLE CRASH, PERSONAL INJURY TO OCCUPANTS MAY OCCUR.
Remedy
DEALERS WILL MAKE MODIFICATIONS TO THE ENERGY ABSORBING MATERIAL LOCATED ABOVE THE HEADLINER IN THE AFFECTED AREA FREE OF CHARGE. THE RECALL BEGAN ON MAY 31, 2006. OWNERS MAY CONTACT MAZDA AT 1-800-222-5500.
Other
Summary
Certain vehicles do not comply with the requirements of CMVSS 206 - Door Locks and Door Retention Components. The rear liftgate latching system does not meet the Technical Standards Document 206 Inertia Load requirement. If the liftgate is left unlocked, it may open during a severe collision. Correction: Dealers will replace the rear liftgate latch release rod and attachment clip.
LATCHES/LOCKS/LINKAGES:HATCHBACK/LIFTGATE:LOCK
Summary
CERTAIN 2004-2005 SPORT UTILITY VEHICLES AND CERTAIN 2001-2003 SPORT UTILITY VEHICLE HAVING REAR LIFTGATE COMPONENTS SERVICED WITH 2004 EQUIVALENT COMPONENTS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 206, 'DOOR LOCKS AND DOOR RETENTION COMPONENTS.' THE REAR LIFTGATE LATCHING SYSTEM DOES NOT MEET THE INERTIA LOAD REQUIREMENT IN ONE DIRECTION.
Potential Consequence
IF THE LIFTGATE IS LEFT UNLOCKED, THERE IS THE POTENTIAL THAT IT MAY OPEN DURING A CRASH.
Remedy
DEALERS WILL REPLACE THE REAR LIFTGATE LATCH RELEASE ROD, THE RELEASE ROD ATTACHMENT CLIP AND THE DOOR HANDLE RETURN SPRING. THE RECALL BEGAN ON MARCH 31, 2005. OWNERS SHOULD CONTACT MAZDA AT 1-800-222-5500.
Generated by Cardog • December 10, 2025
2005 Mazda Tribute
Safety Recalls & Notices
7 Active Recalls
Requires attention
