1996 Ford Contour

Safety Recalls & Notices

We found 19 safety recalls for the 1996 Ford Contour. Recalls are sourced from both NHTSA (US) and Transport Canada databases. Contact your authorized Ford dealer to schedule free repairs.

Total
19
safety notices
Units
185,558
vehicles affected
Recent
Apr 17, 2008
last notice date

Summary

Certain passenger vehicles. The rough surface of the heater blower resistor's stainless steel blades can damage the copper surface of the wiring harness connector. The damage could, over time, cause increased resistance in the connector and, due to subsequent terminal relaxation, result in an open circuit condition. The heater blower resistor may overheat causing the attached electrical connector to melt, creating the potential for a fire. Correction: Dealers will install a new heater blower resistor and a new wire jumper harness.

Campaign ID:2001195
Units Affected:28,272
Contact authorized dealer for service

Summary

On certain vehicles equipped with 2.5 litre V6 engines, tightening of the engine cooling fan motor bearings, up to and including motor stall, can result in increased motor torque and higher than normal motor current and accompanying high motor temperatures. Overheating of the cooling fan motor due to excessive current can result in smoke and odors from bearing grease, insulation and other internal motor components. If electrical current continues to be applied to the motor, internal motor components could ignite possibly igniting other engine compartment components. Correction: Dealers will install a Positive Temperature Coefficient device (a solid state resettable fuse-like device) in-line with each fan motor.

Campaign ID:2000284
Units Affected:22,561
Contact authorized dealer for service

Summary

On certain vehicles, the pressure conscious reducing valve (PCRV) in each of the rear brakes may be subject to malfunction due to corrosion when operated in areas of high road salt use. If both PCRVs malfunction, vehicle handling may be adversely affected during braking as a result of the rear wheels locking, which could potentially result in a vehicle crash. Correction: Dealers will install improved PCRVs in the rear brake system.

Campaign ID:2000077
Units Affected:43,458
Contact authorized dealer for service

Summary

On certain vehicles, the fuel filler pipe vent hose may have less than the intended level of ozone resistance, which could result in the hose becoming brittle and cracking. A cracked hose could result in fuel leakage when the vehicle is being fueled. Fuel leakage in sufficient quantity in the presence of an ignition source could potentially result in a fire. Correction: Dealers will install a fuel filler vent hose containing the appropriate blend of PVC and nitrile rubber.

Campaign ID:1999166
Units Affected:1,301
Contact authorized dealer for service

Summary

On certain vehicles, the terminals at the headlight switch and wiring harness connector may experience heat damage as a result of overheating. This can cause distortion of the terminal and an open circuit in the instrument panel illumination, parking lamp and tail lamp circuits. Correction: Dealers will install a headlamp switch wiring connector containing bronze terminals and inspect and if necessary, replace the headlamp switch.

Campaign ID:1999094
Units Affected:56,107
Contact authorized dealer for service

Summary

On certain vehicles, the floor shift automatic transmission control may be damaged if subjected to certain vehicle interior cleaning products. If exposed to these products, the transmission gear position indicator may deteriorate and not correctly indicate the actual gear position. If this occurs, the shifter will continue to operate normally, but there is the potential for incorrect gear selection. Correction: Automatic transmission floor shift control will be replaced.

Campaign ID:1998208
Units Affected:19,492
Contact authorized dealer for service

Summary

NOTE: VEHICLES EQUIPPED WITH 2.5 LITRE ENGINES. THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. PREMATURE FAILURE OF THE CATALYST SUBSTRATE MATERIAL IN THE CATALYST AND EXHAUST MANIFOLD ASSEMBLIES (LIGHT-OFF CATALYSTS) CAN RESULT IN RESTRICTED EXHAUST GAS FLOW, LOSS OF POWER AND EXHAUST EMISSION LEVELS IN EXCESS OF THOSE SPECIFIED IN THE STANDARD. CORRECTION: LEFT AND RIGHT HAND LIGHT-OFF CATALYSTS WILL BE REPLACED. UNDERBODY CATALYST WILL BE INSPECTED AND REPLACED IF NECESSARY.

Campaign ID:1998103
Units Affected:10,244
Contact authorized dealer for service

Summary

NOTE: ONLY VEHICLES EQUIPPED WITH THE TRACTION CONTROL OPTION ARE INVOLVED. THE THROTTLE CABLES ON THESE VEHICLES MAY HAVE BEEN DAMAGED DURING VEHICLE ASSEMBLY. THIS MAY LEAD TO FRAYING OR SEPARATION OF THE THROTTLE CABLE, WHICH COULD PREVENT THE ENGINE FROM RETURNING TO IDLE. THIS COULD ADVERSELY AFFECT VEHICLE CONTROL. CORRECTION: THROTTLE CABLE WILL BE REPLACED WITH A REVISED DESIGN VERSION.

Campaign ID:1997221
Units Affected:4,123
Contact authorized dealer for service

Summary

FEDERAL MOGUL IS RECALLING 6,903 AFTERMARKET BALL JOINT ASSEMBLIES SHIPPED BETWEEN NOVEMBER 9, 2007 AND MARCH 26, 2008, WHICH MAY HAVE BEEN PACKAGED WITH INCORRECT NUTS. THE PART NUMBERS PACKAGED WITH INCORRECT NUTS ARE: K7147, K7329, K8683, AND 104353. THESE PARTS WERE MADE FOR USE ON THE VARIOUS VEHICLES LISTED ABOVE.

Campaign ID:73206
Component:SUSPENSION

Potential Consequence

THE NUTS INCLUDED IN THE PACKAGING FOR THESE BALL JOINT ASSEMBLIES ARE MISSING THE INTENDED PREVAILING TORQUE (SELF-LOCKING) FEATURE. IF THE INCORRECT NUT WAS TO BECOME LOOSE, THE JOINING MEMBERS MAY LOOSEN LEADING TO A SEPARATION OF THE BALL JOINT. THIS MAY RESULT IN LOSS OF VEHICLE CONTROL, POSSIBLY RESULTING IN A VEHICLE CRASH.

Remedy

FEDERAL MOGUL WILL NOTIFY OWNERS AND REPLACE THE PARTS FREE OF CHARGE. THE RECALL BEGAN ON MAY 22, 2008. OWNERS CAN CONTACT FEDERAL MOGUL AT 877-489-6659.

Contact authorized dealer for service

Summary

CERTAIN AFTERMARKET BRAKE HYDRAULIC MASTER CYLINDERS SOLD AS REPLACEMENT BRAKE CYLINDERS FOR CERTAIN FORD, DAIMLERCHRYSLER, AND JEEP PASSENGER VEHICLES. THESE BRAKE CYLINDERS WERE SOLD UNDER THE BRAND NAMES OF NAPA, RAYBESTOS, AIMCO, AC DELCO, CARQUEST, BENDIX, AND WAGNER. ONLY PRODUCTS THAT WERE MANUFACTURED FROM JULY 27, 2005 THROUGH JANUARY 17, 2006 (DATE CODES 0529 THROUGH 0602) ARE SUBJECT TO THIS RECALL. WHEN SUBJECT TO VERY COLD TEMPERATURES, AN INTERNAL SEAL IN THE MASTER CYLINDER COULD LOSE FLEXIBILITY AND MAY CAUSE BRAKE FLUID TO LEAK.

Campaign ID:61111
Component:SERVICE BRAKES, HYDRAULIC

Potential Consequence

LOSS OF BRAKE FLUID CAN LEAD TO A DECREASE IN BRAKE LINE PRESSURE AND AN INCREASE IN STOPPING DISTANCE, WHICH CAN RESULT IN A VEHICLE CRASH.

Remedy

AFFINIA (BRAKE PARTS, INC.) WILL REPLACE THE SUBJECT BRAKE HYDRAULIC MASTER CYLINDERS FREE OF CHARGE. THE RECALL BEGAN ON MARCH 20, 2006. OWNERS CAN CONTACT AFFINA GROUP CUSTOMER SERVICE AT 1-800-323-0354.

Contact authorized dealer for service

19 Active Recalls

Requires attention

Recent Activity
2008
1 recall
2006
1 recall
2001
3 recalls
Cardog App Icon

Get the Cardog App

Access your vehicle valuations, market insights, and car research tools on the go. Available for both iOS and Android devices.

Download app

Ford Contour by Year

Important Notice
Contact your dealer to verify recalls for your specific VIN and schedule service.

1996 Ford Contour Recall FAQs

Common questions about recalls for this vehicle

Related Recall Checks

Compare recall history with competitors and alternatives to the 1996 Ford Contour.

Show 14 more