Toyota
Prius

It's a known quality defect covered under CSP ZKG. Toyota has received reports of paint peeling on certain vehicles with the original factory-applied Blizzard Pearl or Super White paint colors. These reports indicate that vehicles with these specific paint colors, applied during the vehicle manufacturing process, may experience paint peeling on exterior metal body panels. The Customer Support Program (CSP) provides coverage for involved vehicles with the original factory Blizzard Pearl or Super White paint. The covered condition may occur when sunlight over time degrades the adhesion between the factory-applied paint primer coat layer and the base metal electrodeposition layer causing the paint to peel from the metal body panel. If the condition is verified, the specific panel affected will be repainted. The problem is that I was not notified for my 2010 Prius II and found out today, November 19th, that the paint peeling issue was covered in a CSP. I contacted the Toyota of Richardson service department, Justin Houge, and he referred me to Toyota Headquarters in Plano, TX. I contacted Toyota Headquarters specialist, Amanda, and she informed me that the CSP expired on June 13, 2025 and to contact the dealership for remedy. Attached are photos of the blizzard pearl paint peeling on all four door panels and driver fender panel.

The contact owns 2010 Toyota Prius. The contact stated that while depressing the brake pedal, the ABS, brakes, and the vehicle stability control warning lights were illuminated. An Independent mechanic was contacted. The vehicle was taken to an independent mechanic where it was diagnosed and determined that the brake booster and accumulator needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure and informed the contact that the VIN was not included in the recall; however, the recall had expired. The failure mileage was 172,000.

One day after arriving home from work, all the sudden my ABS light, BRAKE light and traction control light turned on, my brake pedal being harder to push, and my car making weird humming noises every 5 seconds. Upon taking my 2010 Prius to my trusted repair shop, it was revealed that my break actuator was faulty. I drive on roads that need this part to WORK! Especially in the height of construction going on PA. One of the roads that I take has been milled up and upon driving on that road I nearly swerved onto the side walk 3 times! My breaking has been harsh and with one incident that nearly didn't break in time at all! Doing research and looking into the active investigations on this part, it turns out I am one of possible thousands who are dealing with this issue that has all been tied back to the break actuator being faulty which is very expensive to even repair for something that is obviously a poor design.

The brake and pre collision system suddenly fail without warning.

Have multiple warning lamps that light up on and off and the brakes in my car get spongy making the braking unsafe. The lights that turn on are the steering/ traction , brake, and abs light. There are multiple complaints online on YouTube from similar issues ongoing and no recall made. My mechanic says it indicates a leak however there is no brake fluid missing and on YouTube there’s work arounds because people keep getting the same message, yet no recall has been made. This can affect steering and cause an accident. Please recall soon. Including YouTube link so you can see all the comments and issues from thousands that don’t know how to report but view to fix temporarily. [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The ABS, Brake, TSC lights have all appeared on the dash. When running the OBD codes, the error C1391 appears indicating a problem with the ABS pump. When under the dash with the vehicle running, one can hear the abs pump engaging every few seconds which is not normal. After resetting the code. The error quickly pops back up. This is a known problem with this model Prius that Toyota is aware of. Toyota has NOT put out a safety recall for this issue. They refuse to make the repair of a faulty designed abs module, which is obviously a safety concern. The vehicle currently has 128000 miles with no other issues.

It is a known problem that Priuses manufactured from 2004 to 2015 have issues with the brake master cylinder and brake booster accumulator. When the vehicle computer recognizes an internal leak (ABS C1391) or other issue in the accumulator pump, it completely disables the regenerative braking system, which significantly reduces braking power. In my case, the problem is intermittent, and the vehicle computer will occasionally clear the code and operate normally. A slight whirring sound can still be heard (indicative of an internal leak), leading me to conclude that the part is still damaged, even when the code clears itself. This continues to affect my and my passengers' safety because the problem comes back with no warning while driving. Many times at highway speeds, the regenerative braking system will shut off while decelerating. This has caused scares and near-accidents. Imagine you are approaching stopped traffic while traveling 65 miles per hour. You press the brake to start slowing down, and while decelerating, the dashboard lights up and the brake pedal goes spongey. Now, you must slam the brake all the way into the firewall to engage the disks and pads exclusively. Aside from the imminent terror of hitting the car in front of you, now you are skidding on the brakes, worried the car behind you will crush the rear. Sooner or later this will cause somebody to get into an accident when a split-second decision cannot to be made quickly enough. The issue is well-known, and a warranty recall was issued, but it does not cover any vehicles over a certain age and mileage. It has been reproduced by my local mechanic and inspected by a Prius specialist, who both quote about $3800 to fully replace and recalibrate the failing parts. There were no indicators of this issue before it happened to my wife and I the first time on the highway. While I am grateful that nobody was injured, the situation could be completely different had the problem occurred just seconds later.

Brakes have failed with a DTC C1391 indicating an accumulator leak. The brake booster pump constantly runs. When the DTC is triggered the brake feel becomes suddenly different as regen braking is lost. Appears to be a very common and expensive repair. Toyota has already had recalls and extended repair program for these parts but they are now expired and not covered.