Acura
Mdx

Upon startup the following warning lights come on and remain active: Brake System Problem, Power Steering Problem, Hill Start Assist Problem, Vehicle Stability Assist (VSA) Problem, Anti-Lock Break System Problem. Additionally, intermittingly a loud grinding noise can be heard from the button of the vehicle.

Headlights somehow may be taking on moisture. The clarity is down to almost nothing. Driving at night is unsafe! The RPM’s have never been smooth or consistent. There is almost a micro-revving effect. I’ve had all of the fluids and filters changed…… dealership thought it was a recall.

The contact owns a 2014 Acura MDX. The contact stated that while approaching the vehicle after the vehicle had been started, the contact noticed that the taillights were inoperable. The vehicle was taken to an independent mechanic, where it was diagnosed and determined that the taillights assemblies needed to be replaced. The vehicle was repaired; however, the failure recurred approximately two months later. The contact received an email notification of NHTSA Campaign Number: 25V259000 (Exterior Lighting, Interior Lighting), which the contact related to the failure; however, the VIN was not included in the recall. The dealer was notified of the failure. The manufacturer was notified of the failure, but no assistance was provided. The failure mileage was approximately 99,000.

The power train experiences jutters. Known issue and many torque converters have been replaced while under warranty. Our vehicle had minimal miles when warranty expired and now this problem has occurred. Have followed all of the recommended technical bulletins from Honda and the issue is not resolved. They now say to replace the torque converter at own expense.

Large spot of paint has peeled off, exposing bare metal in front of the sunroof and above the windshield in the center of the roof.

The car is un safe to drive, the RPM fluctuations, gos up and down at low speed, doesn’t potential problems with the torque converter clutch, is juddering and unstable RPMs, noticeable during acceleration or deceleration

The EPS system failed while driving on a major highway. I was in the passing (left) lane, and had to manually steer the vehicle. I had to have the vehicle towed to the dealership. The service department has had the vehicle for almost 2 weeks. They said that when they ran the diagnostic, there was a code. They cleared the code, and drove the vehicle. They were unable to duplicate the incident. The service advisor said it may have been a “glitch.” That’s an extremely dangerous “glitch.” I have read that many other people have had the same issue with the same vehicle. This may have fatal consequences. If I had not been strong enough to steer the vehicle, I may have experienced a relatively high-speed collision.

I change my own engine oil every 3,000 miles. During the past year with three oil changes completed, I have observed aluminum pieces in the bottom of the oil change black pan. Because my wife's 2017 Acura TLX was the subject of the crankshaft and connecting rod campaign (the dealer had to replace the crankshaft and all of the connecting rod and main bearings) I am familiar with the issue of non-concentric crankshaft connecting rod journals, and so have been surprised that my 2014 MDX with the same 3.5 L V6 has not yet been included. I am pretty sure it does suffer from the same defect as evidenced by the aluminum in the engine oil. If it fails at hihway speeds, that would possibly cause a safety incident.