Safety Recalls & Notices
Requires attention
Issue: On certain vehicles, the plastic emblem on the steering wheel airbag cover could detach and become a projectile when the airbag inflates in a crash. Note: This recall is for certain vehicles that had the steering wheel airbag replaced. Safety Risk: Projectiles in the occupant compartment could increase the risk of an injury. Corrective Actions: Nissan will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the steering wheel airbag cover.
ON CERTAIN MINI VANS EQUIPPED WITH A FOLDING THIRD ROW REAR SEAT, WHEN THE THIRD ROW SEAT IS RAISED FROM ITS STOWED POSITION, IT ENGAGES STRIKER BRACKETS, ONE ON EACH SIDE OF THE SEAT CUSHION. THE FOLD-AWAY STRIKER LOOP IS WELDED TO A MOUNTING BRACKET. THE STRIKER MAY BECOME DETACHED FROM ITS MOUNTING BRACKET DUE TO A BROKEN WELD AT THE POINT OF ATTACHMENT TO THE BRACKET.
IF THE THIRD ROW SEAT STRIKER WELD FAILS, THE STRIKER COULD SEPARATE FROM THE MOUNTING BRACKET. STRIKER SEPARATION COULD AFFECT THE RISK OF INJURY IN CERTAIN TYPES OF CRASHES.
DEALERS WILL REPLACE THE THIRD ROW SEAT STRIKER BRACKETS FREE OF CHARGE. THE RECALL BEGAN ON DECEMBER 19, 2005. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
ON CERTAIN MINI VANS, THERE IS A SEAT ADJUSTMENT MECHANISM THAT CONTAINS EXPOSED MOVING COMPONENTS LOCATED AT THE REAR INSIDE EDGE OF THE SECOND ROW SEAT.
WHEN THE OPERATOR ATTEMPTS SEAT ADJUSTMENT, A FINGER MAY BE PINCHED IN THE MOVING SEAT ADJUSTMENT MECHANISM WHICH COULD CAUSE AN INJURY.
ON EARLIER MODEL VEHICLES BUILT THROUGH JUNE 28, 2004, DEALERS WILL REPLACE THE INBOARD SECOND ROW SEAT ADJUSTMENT HANDLE, RIVET A PLASTIC REINFORCEMENT TO BACKSIDE OF THE EXISTING SEAT BACK COVER CARPETING, INSTALL TIE-DOWNS AND A FLANGE TO THE INBOARD SIDE SHIELD. ON VEHICLES PRODUCED FROM JUNE 29, 2004 THROUGH SEPTEMBER 26, 2005, DEALERS WILL RIVET A PLASTIC REINFORCEMENT TO THE BACKSIDE OF THE EXISTING SEAT BACK COVER CARPETING, INSTALL TIE-DOWNS AND A FLANGE ON THE INBOARD SIDE SHIELD. THE RECALL BEGAN ON DECEMBER 19, 2005. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
On certain vehicles, a third row seat bracket striker may become detached from its mounting bracket due to a broken weld at the point of attachment. Striker separation may increase the risk of injury to seat occupants in certain types of collisions. Correction: The third row seat striker brackets will be replaced.
On certain vehicles, the seat adjustment mechanism contains exposed moving metal components located at the rear inside edge of the second row seat. An operators finger may be pinched in the mechanism during seat adjustment. Correction: Dealers will install a plastic reinforcement to the backside of the existing seat back cover carpeting.
ON CERTAIN MINIVANS EQUIPPED WITH A POWER SLIDING DOOR(S), AT AN AMBIENT TEMPERATURE BELOW APPROXIMATELY 40 DEGREES FAHRENHEIT, THE ACTUATOR FOR THE POWER SLIDING DOOR(S) MAY EXPERIENCE BINDING DUE TO AN OUT-OF-SPECIFICATION CONDITION. IN ORDER TO OPEN, CLOSE OR REVERSE A POWER SLIDING DOOR, THE SHIFT SELECTOR LEVER MUST BE IN "PARK." IF THE ACTUATOR IS EXPERIENCING BINDING AND THE DRIVER SHIFTS THE VEHICLE OUT OF "PARK" WHILE A POWER SLIDING DOOR IS STILL CLOSING, THE DOOR LATCHES MAY NOT ENGAGE.
THIS CAN RESULT IN THE DOOR COMING OPEN UNEXPECTEDLY UPON RAPID ACCELERATION, AND AN OCCUPANT COULD FALL OUT OF THE DOOR AND BE INJURED.
DEALERS WILL REPLACE THE ACTUATOR FOR THE POWER SLIDING DOOR(S). OWNER NOTIFICATION BEGAN ON JUNE 23, 2004. OWNERS SHOULD CONTACT NISSAN AT 1-800-647-7261.
On certain vehicles equipped with a power sliding door(s), at an ambient temperature below approximately 4 degrees Celsius, the actuator for the power sliding door(s) may bind. In order to open, close or reverse a power sliding door, the shift selector lever must be in PARK. If the actuator is experiencing binding and the driver shifts the vehicle out of PARK while a power sliding door is still closing, the door latches may not engage. This can result in the door coming open unexpectedly upon rapid acceleration. Correction: Dealer will replace the actuator for the power sliding door(s).
On vehicles equipped with the automatic airbag suppression feature option, the front passenger seat is equipped with a seat cushion bladder and sensors used for occupant detection. When a certain child dummy is placed in the required positions for US Government tests, automatic suppression may not occur. Correction: Dealers will inspect the front passenger seat cushion/sensor assembly. If the seat cushion/sensor is found to be operating improperly, the seat will be removed and recalibrated. Nissan in the United States is conducting this safety recall campaign to correct an out of compliance condition with US regulations. While there are approximately 1,524 vehicles in Canada affected by this condition, Canadian regulations in this area differ from those in the United States and thus Canadian vehicles are not out of compliance. However, in the interest of customer satisfaction, Nissan Canada Inc., will be conducting a Voluntary Customer Satisfaction Initiative to have owners of affected Canadian vehicles return to their dealers for inspection and recalibration if required.
CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH THE ADVANCED AIR BAG REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION." THE AIR BAG FOR THE FRONT PASSENGER SEAT IS TO BE TURNED OFF (SO THAT IT DOES NOT INFLATE) WHEN CERTAIN OCCUPANTS, SUCH AS SMALL CHILDREN, ARE IN THE FRONT SEAT.
THIS REDUCES THE RISK OF SUCH OCCUPANTS BEING UNJURED BY AN INFLATING AIR BAG IN A COLLISION.
DEALERS WILL INSPECT THE FRONT PASSENGER SEAT CUSHION/SENSOR ASSEMBLY. IF THE SEAT CUSHION/SENSOR IS FOUND TO BE OPERATING IMPROPERLY, THE SEAT WILL BE REMOVED AND RECALIBRATED. OWNER NOTIFICATION BEGAN ON JUNE 23, 2004. OWNERS SHOULD CONTACT NISSAN AT 1-800-647-7261.
Generated by Cardog • December 11, 2025
Safety Recalls & Notices
Requires attention