1988 Ford Ranger
Safety Recalls & Notices
We found 6 safety recalls for the 1988 Ford Ranger. Recalls are sourced from both NHTSA (US) and Transport Canada databases. Contact your authorized Ford dealer to schedule free repairs.
Summary
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. NITROUS OXIDE LEVELS EXCEED THE STANDARD. CORRECTION: OWNERS WILL BE PROVIDED WITH REVISED STARTING INSTRUCTIONS FOR THE OWNER GUIDE. CERTAIN VEHICLES WILL HAVE THE ENGINE EMISSIONS CONTROL SYSTEMS MODIFIED AND EXHAUST SYSTEM CATALYSTS REPLACED.
Summary
THIS RECALL SUPERSEDES RECALL 90-27 FOR VEHICLES IN THE MARITIMES. THE THROTTLE MAY STICK IN AN OPEN POSITION DUE TO LINKAGE BINDING CAUSED BY CORROSION. THIS WOULD CAUSE THE ENGINE TO RUN AT HIGHER THAN IDLE SPEED WHEN THE THROTTLE IS RELEASED AND COULD ADVERSELY AFFECT DRIVER CONTROL RESULTING IN A POSSIBLE CRASH. CORRECTION: A STAINLESS STEEL SLEEVE, WHICH WILL BE PLACED OVER THE HUB ON THE THROTTLE BODY ASSEMBLY, AND A SECONDARY THROTTLE LEVER TO FIT THE SLEEVE, ALONG WITH OTHER MOUNTING PARTS, WILL BE INSTALLED ON AFFECTED VEHICLES.
Summary
RANGER/BRONCO II - 2.9 LITRE ENGINES TAURUS/SABLE - 3.0 LITRE ENGINES NOTE: VEHICLES LOCATED IN NEWFOUNDLAND, NOVA SCOTIA, NEW BRUNSWICK AND PRINCE EDWARD ISLAND. THE THROTTLE MAY STICK IN AN OPEN POSITION DUE TO LINKAGE BINDING CAUSED BY CORROSION. THIS WOULD CAUSE THE ENGINE TO RUN AT HIGHER THAN IDLE SPEED WHEN THE THROTTLE IS RELEASED AND COULD ADVERSELY AFFECT DRIVER CONTROL RESULTING IN A POSSIBLE CRASH. CORRECTION: ON VEHICLES WITH 2.9 LITRE ENGINES, DEALERS WILL CLEAN, MODIFY AND LUBRICATE THE HUB PIN AND LEVER BUSHINGS WITH A MARINE-TYPE ANTI-SEIZE GREASE. ADDITIONALLY, ON VEHICLES WITH 3.0 LITRE ENGINES, THE HUB PIN LEVER ASSEMBLY WILL BE REPLACED. NOTE: THIS RECALL HAS BEEN SUPERSEDED BY RECALL NO. 91021.
Summary
VEHICLES WERE BUILT WITH INCORRECT REAR BRAKE ASSEMBLIES. THESE BRAKE ASSEMBLIES MAY INCREASE STOPPING DISTANCES AND REDUCE VEHICLE CONTROL WHILE BRAKING. THIS COULD RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING. CORRECTION: REAR BRAKE ASSEMBLIES WILL BE REPLACED.
Summary
EQUIPMENT DESCRIPTION: AFTERMARKET BRAKE ROTORS FOR USE ON CERTAIN FORD AND MAZDA TRUCKS. CRACKED CASTINGS CAUSED CRACKS TO APPEAR ON THE OUTER DIAMETER OF THE ROTOR HAT OR AROUND THE STUD HOLE.
Potential Consequence
LOSS OF BRAKING CAN RESULT.
Remedy
AIMCO WILL REIMBURSE CONSUMERS/INSTALLERS FOR THE COST OF REPLACEMENT ROTORS AND INSTALLATION. CONSUMERS ARE REQUESTED TO RETURN TO THE LOCATION WHERE THE ROTORS WERE ORIGINALLY PURCHASED/INSTALLED FOR REPLACEMENT.
Summary
TRUCKS WERE BUILT WITH INCORRECT REAR BRAKE ASSEMBLIES. CONSEQUENCE OF DEFECT: A TENDENCY FOR REAR BRAKE LOCKUP WOULD EXIST PARTICULARLY DURING HEAVY BRAKE APPLICAION WITH A LIGHTLY LOADED TRUCK. ALSO, INCREASED STOPPING DISTANCE WOULD BE REQUIRED IF THE BRAKE MODULATION (PUMPING THE BRAKES) IS USED TO CONTROL THE VEHICLE DURING A HARD BRAKE STOP.
Remedy
REPLACE REAR BRAKE ASSEMBLIES.
6 Active Recalls
Requires attention
1988 Ford Ranger Recall FAQs
Common questions about recalls for this vehicle
Related Recall Checks
Compare recall history with competitors and alternatives to the 1988 Ford Ranger.