Honda
Ridgeline

The rearview camera continues to fail after recall for the issue was completed. Estimate 6 months+ since recall was performed to replace camera tailgate wire harness. It has begun random failures again. There is no indication from the dash of an error. When placed in reverse, the camera display in the dash goes nearly black or totally black; sometimes lane back lines are present, sometimes not. The current problem is entirely consistent with the failure conditions and symptoms prior to the recall update to replace the wire harness. The problem can fairly routinely be triggered by multiple uses of the dual-action tailgate movement. A few flat down and back up, then a few swing-gate actions will generally trigger the failure. When the camera monitor does have a normal picture, it will stay that way indefinitely -until you again have repeated tailgate movements using the dual-action feature. It is generally possible to perform several dual-action movements of the tailgate and restore the camera monitor to a functional view. The recall and replacement with an "improved" wire harness has failed to last; the identical problem is recurring. The vehicle was at a Honda dealer today. They report no error codes, they report no continuity issues with the wire harness. Proposed remedy is to replace the camera unit, despite no error codes. The only basis seems to be that they could not "see" a problem with the harness. Nor can they explain why the circumstances are identical to what caused the initial recall, but still feel it's not the cable. Nor can they explain why my repeated movements of the tailgate can make the display work again. This is a considerable safety issue as it's extremely difficult to back up the vehicle if you can't see behind/below the tailgate. Mirrors are not enough; safe backing requires the use of the rear view camera.

While driving down the road the lower passenger side rear door garnish flew off the truck and went flying out of the wheel well.

RVC rearview camera is not functioning.

The collision breaking will fire off automatically in situations where you’re going around a curve and there’s a car coming in the opposite direction. The truck will see the other car and slam on the brakes even though everybody’s in the correct lane it’s terribly dangerous because it basically is brake checking people who are behind you. There’s no rhyme or reason to it. It does not always do it. It just does it sometimes You can turn the system off, but you have to do that every single time that you turned the car on and it’s I’m sure caused many wrecks at this point.

I was leaving a place of business crossing a four lane undivided road legally to make a left turn. There was an oncoming car (at an unknown speed) in the lane I was crossing approaching rapidly. I just needed to accelerate lightly to be clear. The collision braking system activated before I could clear. The driver was headed straight for me with a broadside collision imminent. He swerved at the last minute and avoided me by heading into the oncoming traffic lane ( no oncoming cars were present). Results could have been ugly. I have to manually turn that feature off every time I start the vehicle, unless you can have it disabled for me. I do not want my vehicle making decision which I cannot control. Thank you for addressing this matter and a response would be appreciated.

The automatic high beam system is terrible. It is too sensitive so the beams flash hi/low on and off. Even a small road reflector on a dark empty road will force it back to low beam. Other cars I own with this type system work much better. It’s a safety hazard because auto hi-beam is on by default and you can’t count on it providing the correct amount of lighting when on dark roads, plus it annoys oncoming drivers because of the constant flashing.

Inner tie rods unnaturally worn. Steering was loose. Internal play in the rack Steering Gearbox, Electric Power Steering needed replacement Honda stated this was similar to manufacturing problems they had with Civics but that Ridgeline was not part of the recall. Issue was fixed by Honda but at my cost.

The auto high beam system on my 2023 Honda Ridgeline frequently malfunctions. It prematurely dims the high beams when approaching reflective road signs or street lighting, even with no oncoming traffic present. More concerning, the system immediately reactivates high beams afterward — sometimes directly into the eyes of oncoming drivers, creating a blinding hazard. This behavior has occurred multiple times during rural and suburban nighttime driving. Honda offers no way to adjust the system’s sensitivity, even the one in the dask computer dont help and dealerships confirm that no fix or update is currently available. The system appears to be functioning “as designed,” but the result is erratic and unpredictable headlight behavior that undermines safety. I am submitting this report to document repeated false activations and to support investigation or revision of this feature.