2002 Excursion

On certain 2011 Ranger vehicles, the multi-function switch, installed during vehicle assembly, could malfunction and fail. Additionally, other vehicle models may have received the affected switch as a replacement part during service, and are therefore also involved in this campaign. Failure of the multi-function switch could result in a loss of turn signal, tail lamp, hazard warning signal flasher and/or stop lamp function. Failure of these lighting components to illuminate may result in the following road users being unaware of the driver's intentions, as well as reducing vehicle conspicuity during hours of darkness, which could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the multi-function switch.

2011251 · 5,815 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

FORD IS RECALLING CERTAIN MODEL YEAR 2011 RANGER TRUCKS BUILT FROM JANUARY 25, 2011, THROUGH APRIL 25, 2011 AT THE TWIN CITIES ASSEMBLY PLANT, AND SERVICE PARTS DISTRIBUTED TO DEALERS FOR CERTAIN 2004 THROUGH 2011 MODEL YEAR RANGER TRUCKS, 2002 THROUGH 2005 MODEL YEAR EXCURSION VEHICLES, AND 2002 THROUGH 2007 MODEL YEAR F-250, F-350, F-450, AND F-550 TRUCKS FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THE MULTI-FUNCTION SWITCH WAS SHIPPED WITH A SUBCOMPONENT (SLIDER) THAT MAY EXPERIENCE DEFORMATION. A MULTI-FUNCTION SWITCH WITH A DEFORMED SLIDER MAY MALFUNCTION CAUSING THE TURN SIGNAL, TAIL LIGHTS, HAZARD WARNING SIGNAL FLASHERS AND/OR BRAKE LIGHTS NOT TO ACTIVATE.

11V352000 · 26,715 units in campaign · NHTSA

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

On certain vehicles, the speed control deactivation switch may overheat, smoke, or burn, potentially resulting in an underhood fire. The condition may occur either when the vehicle is parked or when it is in operation. Correction: Dealers will install a new switch or fused wiring harness. Note: This is an expansion of recall 2005028 (05S28) for vehicles not previously included in the campaign.

2009292 · 492,877 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

FORD IS RECALLING MODEL YEARS 1995-2003 WINDSTAR, 2000-2003 EXCURSION DIESEL, 1993-1997 AND 1999-2003 F-250 SD THROUGH F-550 SD DIESEL, 1992-2003 E-150 THROUGH E-550, 1995-2002 EXPLORER, 1997 AND 2002 MERCURY MOUNTAINEER, 1995-1997 AND 2001-2003 RANGER, AND 1994 F53 VEHICLES EQUIPPED WITH THE TEXAS INSTRUMENTS SPEED CONTROL DEACTIVATION SWITCH (SCDS). THE SCDS MAY LEAK INTERNALLY AND THEN OVERHEAT, SMOKE, OR BURN.

09V399000 · 4,500,000 units in campaign · NHTSA

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

CERTAIN FEDERAL-MOGUL REPLACEMENT WHEEL HUB ASSEMBLIES WITH THE BRAND NAMES: NATIONAL, CARQUEST P/NOS. 515020, 515021, 515025, 515053, 515054, 515059, AND 515060, SHIPPED BETWEEN JANUARY 23, 2006, AND DECEMBER 20, 2007, SOLD FOR LIGHT DUTY AND MEDIUM DUTY TRUCKS. THE INBOARD RETENTION NUT USED TO MAINTAIN HUB BEARING ASSEMBLY CAN LOOSEN RESULTING IN AN ABS LIGHT INDICATION, NOISE, AND/OR WHEEL SEPARATION.

07E106000 · 130,000 units in campaign · NHTSA

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

On certain vehicles equipped with a 7.3L diesel engine, the camshaft position sensor may fail, causing the engine to stall. Engine stalling would result in lost propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash. Correction: Dealers will inspect and, if required, replace the camshaft position sensor.

2007403 · 95,484 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH 7.3L DIESEL ENGINES, THE CAMSHAFT POSITION SENSOR LOCATED ON THE ENGINE OF THE VEHICLE MAY FUNCTION INTERMITTENTLY, POSSIBLY RESULTING IN AN ENGINE STALL.

07V553000 · 1,176,000 units in campaign · NHTSA

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

ON CERTAIN TRUCKS EQUIPPED WITH SPEED CONTROL, GASOLINE OR NATURAL GAS ENGINES, THE SPEED CONTROL DEACTIVATION SWITCH MAY OVERHEAT.

06V286000 · 1,200,000 units in campaign · NHTSA

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

On certain vehicles, the speed control deactivation switch may overheat, smoke, or burn, potentially resulting in an underhood fire. The condition may occur either when the vehicle is parked or when it is in operation. Correction: Initially as an interim repair, owners will be instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected. As soon as replacement parts are available, owners will be instructed to return to the dealers for installation of a new switch or fused wiring harness.

2005028 · 304,417 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer