Pontiac · 1990–2005
Grand Am Recalls
39 known recalls affecting the Pontiac Grand Am (1990–2005). Enter your VIN to check if your specific vehicle is affected, or browse by model year below.
Pontiac Grand Am Recalls
Summary
On certain vehicles, a defect in the ignition switch could allow the switch to move out of the "run" position if the key ring is carrying added weight or the vehicle goes off-road or is subjected to some other jarring event. If this were to occur, engine power, power steering and power braking would be affected, increasing the risk of a crash causing injury and/or damage to property. The timing of the key movement out of the “run” position, relative to the activation of the sensing algorithm of the crash event, may also result in the airbags not deploying in a subsequent collision, increasing the risk of injury. Correction: For each key, dealers will install two key rings and modify the key ring opening shape. Note: Until the correction is performed, all items should be removed from the key ring.
Summary
Certain vehicles were built with rear suspension knuckle bolts that are not to specification and could fracture under high loads that can occur in some driving conditions. If the bolt fractures, the rear suspension linkage could detach from the knuckle and the rear wheel would be able to turn inboard or outboard. Sudden changes could occur in vehicle handling and, particularly at higher speeds, the driver may not be able to control the vehicle and a crash could occur without warning. Correction: Dealers will replace both rear suspension knuckle bolts.
Summary
On certain vehicles, in hot ambient conditions, the accelerator pedal arm may stick at the attachment to the bracket and not return to the engine idle position when the operator removes the actuating force from the accelerator pedal. If the accelerator pedal does not return to the engine idle position, the throttle valve will not close, which may result in an increased stopping distance. Correction: Dealers will inspect the accelerator pedal arm and, if necessary, replace the accelerator and brake pedal assembly.
Summary
On certain vehicles, a weld on the fuel tank may be insufficient, resulting in a fuel leak. If this were to occur the operator may notice a strong fuel smell and some dampness on the ground. If a sufficient amount of fuel were to leak out and if an ignition source were present, a vehicle fire could occur. Correction: Dealers will inspect the fuel tank, and replace, if necessary.
Summary
On certain vehicles, if the engine fails to start and the driver holds the key in the "Start" position for an extended period, high current flowing through the ignition switch may produces enough heat to melt internal switch parts. If the switch is damaged, a fire could occur in the steering column, even with the engine off and the key removed. Correction: Dealer will install a relay kit to prevent high current from flowing through the ignition switch.
Summary
On certain vehicles, the hazard warning switch may experience solder joint cracking if subjected to rapid temperature transition. If solder joint cracking occurs and results in an open circuit, the turn signals/hazard lamps become intermittent or inoperative. Correction: Dealers will replace the hazard warning switch.
Summary
Certain vehicles, after being exposed to substantial amounts of water, may experience deployment of either the driver or passenger front airbag without a crash. The owner’s manual for these vehicles does not provide specific information about this situation. Inadvertent deployment of the driver and / or passenger front airbag in a non-accident (non-impact) situation may cause damage to the surrounding vehicle environment (windshield / instrument panel), and create expensive vehicle repair, including replacement of the airbag module(s) and the Sensing and Diagnostic Module (SDM). In some instances, inadvertent deployment could cause minor injuries to vehicle occupants. Correction: GM will notify the owners of these 1996 and 1997 vehicles of the potential affect of water accumulating in the vehicle interior on the function of the airbag system (as included in the owner's manuals of 1998 and later model years vehicles).
Summary
On certain passenger vehicles if the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts. If the switch is damaged, a fire could occur in the steering column, even with the engine off and the key removed. Correction: Dealers will install a relay kit in these vehicles to prevent high current from flowing through the ignition switch.
Summary
Certain vehicles do not comply with the requirements of CMVSS 101- Location and Identification of Controls and Displays. Vehicles exhibit a condition in which the "Generator Low Voltage" indicator light will not illuminate under low voltage conditions. Correction: Dealers will reflash the vehicle PCM with new calibration software.
Summary
On certain vehicles, the electrical current through the ignition switch is above design capacity. Over time, this excessive current damages the ignition switch and may result in a fire in the vicinity of the steering column ignition switch which could spread to other parts of the vehicle's interior. Correction: Dealers will install a relay kit and, if necessary, replace the ignition switch and steering column tilt lever.
Showing 1-10 of 39 recalls
Related Recall Checks
Check recalls for specific Pontiac Grand Am model years