2006 Nissan Quest
Safety Recalls & Notices
4 Active Recalls
Requires attention
Airbag
Summary
Issue: On certain vehicles, the plastic emblem on the steering wheel airbag cover could detach and become a projectile when the airbag inflates in a crash. Note: This recall is for certain vehicles that had the steering wheel airbag replaced. Safety Risk: Projectiles in the occupant compartment could increase the risk of an injury. Corrective Actions: Nissan will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the steering wheel airbag cover.
Airbag
Summary
On certain vehicles, the 3rd-row curtain side-impact airbag on the driver's side may have been installed slightly out of position during vehicle assembly. This could cause the airbag to inflate in a manner different than designed or not inflate at all. The most likely result of this mis-installation is a delayed deployment. Nissan testing has determined that the delay would be about 20 msc compared with the design intent, and the bag will still be inflated before a 3rd-row occupant might interact with it in a side impact crash. Testing also determined that in the event of a non-deployment, the vehicle still exceeds all safety requirements in the third row seats. Correction: Dealers will inspect and, if required, reposition the 3rd-row curtain side-impact airbag. This action is deemed a voluntary service campaign and is not being conducted under the Motor Vehicel Safety Act.
SEATS:MID/REAR ASSEMBLY
Summary
ON CERTAIN MINI VANS, THERE IS A SEAT ADJUSTMENT MECHANISM THAT CONTAINS EXPOSED MOVING COMPONENTS LOCATED AT THE REAR INSIDE EDGE OF THE SECOND ROW SEAT.
Potential Consequence
WHEN THE OPERATOR ATTEMPTS SEAT ADJUSTMENT, A FINGER MAY BE PINCHED IN THE MOVING SEAT ADJUSTMENT MECHANISM WHICH COULD CAUSE AN INJURY.
Remedy
ON EARLIER MODEL VEHICLES BUILT THROUGH JUNE 28, 2004, DEALERS WILL REPLACE THE INBOARD SECOND ROW SEAT ADJUSTMENT HANDLE, RIVET A PLASTIC REINFORCEMENT TO BACKSIDE OF THE EXISTING SEAT BACK COVER CARPETING, INSTALL TIE-DOWNS AND A FLANGE TO THE INBOARD SIDE SHIELD. ON VEHICLES PRODUCED FROM JUNE 29, 2004 THROUGH SEPTEMBER 26, 2005, DEALERS WILL RIVET A PLASTIC REINFORCEMENT TO THE BACKSIDE OF THE EXISTING SEAT BACK COVER CARPETING, INSTALL TIE-DOWNS AND A FLANGE ON THE INBOARD SIDE SHIELD. THE RECALL BEGAN ON DECEMBER 19, 2005. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
Seats And Restraints
Summary
On certain vehicles, the seat adjustment mechanism contains exposed moving metal components located at the rear inside edge of the second row seat. An operators finger may be pinched in the mechanism during seat adjustment. Correction: Dealers will install a plastic reinforcement to the backside of the existing seat back cover carpeting.
Generated by Cardog • December 13, 2025
2006 Nissan Quest
Safety Recalls & Notices
4 Active Recalls
Requires attention
