Safety Recalls & Notices
Requires attention
Issue: On certain vehicles, the plastic emblem on the steering wheel airbag cover could detach and become a projectile when the airbag inflates in a crash. Note: This recall is for certain vehicles that had the steering wheel airbag replaced. Safety Risk: Projectiles in the occupant compartment could increase the risk of an injury. Corrective Actions: Nissan will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the steering wheel airbag cover.
On certain vehicles, the 3rd-row curtain side-impact airbag on the driver's side may have been installed slightly out of position during vehicle assembly. This could cause the airbag to inflate in a manner different than designed or not inflate at all. The most likely result of this mis-installation is a delayed deployment. Nissan testing has determined that the delay would be about 20 msc compared with the design intent, and the bag will still be inflated before a 3rd-row occupant might interact with it in a side impact crash. Testing also determined that in the event of a non-deployment, the vehicle still exceeds all safety requirements in the third row seats. Correction: Dealers will inspect and, if required, reposition the 3rd-row curtain side-impact airbag. This action is deemed a voluntary service campaign and is not being conducted under the Motor Vehicel Safety Act.
ON CERTAIN MINI VANS EQUIPPED WITH A FOLDING THIRD ROW REAR SEAT, WHEN THE THIRD ROW SEAT IS RAISED FROM ITS STOWED POSITION, IT ENGAGES STRIKER BRACKETS, ONE ON EACH SIDE OF THE SEAT CUSHION. THE FOLD-AWAY STRIKER LOOP IS WELDED TO A MOUNTING BRACKET. THE STRIKER MAY BECOME DETACHED FROM ITS MOUNTING BRACKET DUE TO A BROKEN WELD AT THE POINT OF ATTACHMENT TO THE BRACKET.
IF THE THIRD ROW SEAT STRIKER WELD FAILS, THE STRIKER COULD SEPARATE FROM THE MOUNTING BRACKET. STRIKER SEPARATION COULD AFFECT THE RISK OF INJURY IN CERTAIN TYPES OF CRASHES.
DEALERS WILL REPLACE THE THIRD ROW SEAT STRIKER BRACKETS FREE OF CHARGE. THE RECALL BEGAN ON DECEMBER 19, 2005. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
ON CERTAIN MINI VANS, THERE IS A SEAT ADJUSTMENT MECHANISM THAT CONTAINS EXPOSED MOVING COMPONENTS LOCATED AT THE REAR INSIDE EDGE OF THE SECOND ROW SEAT.
WHEN THE OPERATOR ATTEMPTS SEAT ADJUSTMENT, A FINGER MAY BE PINCHED IN THE MOVING SEAT ADJUSTMENT MECHANISM WHICH COULD CAUSE AN INJURY.
ON EARLIER MODEL VEHICLES BUILT THROUGH JUNE 28, 2004, DEALERS WILL REPLACE THE INBOARD SECOND ROW SEAT ADJUSTMENT HANDLE, RIVET A PLASTIC REINFORCEMENT TO BACKSIDE OF THE EXISTING SEAT BACK COVER CARPETING, INSTALL TIE-DOWNS AND A FLANGE TO THE INBOARD SIDE SHIELD. ON VEHICLES PRODUCED FROM JUNE 29, 2004 THROUGH SEPTEMBER 26, 2005, DEALERS WILL RIVET A PLASTIC REINFORCEMENT TO THE BACKSIDE OF THE EXISTING SEAT BACK COVER CARPETING, INSTALL TIE-DOWNS AND A FLANGE ON THE INBOARD SIDE SHIELD. THE RECALL BEGAN ON DECEMBER 19, 2005. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
On certain vehicles, a third row seat bracket striker may become detached from its mounting bracket due to a broken weld at the point of attachment. Striker separation may increase the risk of injury to seat occupants in certain types of collisions. Correction: The third row seat striker brackets will be replaced.
On certain vehicles, the seat adjustment mechanism contains exposed moving metal components located at the rear inside edge of the second row seat. An operators finger may be pinched in the mechanism during seat adjustment. Correction: Dealers will install a plastic reinforcement to the backside of the existing seat back cover carpeting.
Generated by Cardog • December 13, 2025
Safety Recalls & Notices
Requires attention