2006 Subaru Forester
Safety Recalls & Notices
5 Active Recalls
Requires attention
Suspension
Summary
On certain vehicles, the front lower control arms could corrode due to exposure to humid environments and road de-icing chemicals. Over time, corrosion could progress causing thinning and perforation of the steel, which could allow the control arm to fracture near the forward pivot attachment to the chassis. Lower control arm failure could result in a loss of vehicle control and a crash causing property damage and/or personal injury. Correction: Dealers will inspect the front lower control arms and, depending on the degree of corrosion exhibited, will either rustproof or replace them.
SUSPENSION:FRONT:CONTROL ARM:LOWER ARM
Summary
SUBARU IS RECALLING CERTAIN MODEL YEAR 2002-2007 IMPREZA, MODEL YEAR 2003-2008 FORESTER, AND MODEL YEAR 2005-2006 SAAB 9-2X VEHICLES MANUFACTURED FROM SEPTEMBER 5, 2000 THROUGH NOVEMBER 26, 2007 ORIGINALLY SOLD, OR CURRENTLY REGISTERED IN, MASSACHUSETTS, MARYLAND, MICHIGAN, NEW HAMPSHIRE, NEW YORK, PENNSYLVANIA, VERMONT, WISCONSIN, CONNECTICUT, DELAWARE, IOWA, ILLINOIS, INDIANA, MAINE, MINNESOTA, MISSOURI, NEW JERSEY, OHIO, RHODE ISLAND, WEST VIRGINIA AND THE DISTRICT OF COLUMBIA. THE FRONT LOWER CONTROL ARMS MAY BREAK AT THE HANGER BRACKETS DUE TO CORROSION IF THE HANGER BRACKET IS EXPOSED TO SALTY AND HUMID ENVIRONMENTS SUCH AS ROADS CONTAINING SNOW MELTING AGENT.
Potential Consequence
A BROKEN CONTROL ARM CAN RESULT IN THE LOSS OF CONTROL OF THE VEHICLE, INCREASING THE RISK OF A CRASH.
Remedy
SUBARU WILL HANDLE THEIR VEHICLES AND SAAB WILL HANDLE THEIRS. DEALERS WILL INSPECT THE DEGREE OF CORROSION OF THE FRONT LOWER CONTROL ARMS, AND WILL EITHER RUSTPROOF OR REPLACE THEM. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN DURING DECEMBER 2011. OWNERS MAY CONTACT SUBARU AT 1-800-782-2783. OWNERS MAY CONTACT SAAB AT 1-800-955-9007.
AIR BAGS:FRONTAL
Summary
ON CERTAIN VEHICLES, THE WIRING HARNESS FOR THE AIR BAG OCCUPANT DETECTION SYSTEM IN THE FRONT PASSENGER SEAT MAY HAVE BEEN PINCHED DURING PRODUCTION. PINCHING OF THE WIRING HARNESS BETWEEN THE FLOOR CROSSMEMBER AND THE SEAT MOUNTING BRACKET COULD RESULT IN A SHORT CIRCUIT.
Potential Consequence
THE PASSENGER'S FRONT AIR BAG COULD BECOME DISABLED AND MAY NOT DEPLOY IN THE EVENT OF A CRASH INCREASING THE RISK OF INJURY TO THE SEAT OCCUPANT. ALSO AN ELECTRICAL SHORT CIRCUIT COULD CAUSE A FIRE.
Remedy
DEALERS WILL INSPECT TO SEE IF THE WIRING HAD BEEN INCORRECTLY ROUTED UNDER THE SEAT BRACKET. IF SO, THE DEALER WILL REPAIR ANY DAMAGED WIRING, REROUTE AND SECURE THE WIRING HARNESS IN THE CORRECT LOCATION, AND RE-CALIBRATE THE OCCUPANT DETECTION SYSTEM AS NECESSARY. THE RECALL BEGAN ON MARCH 9, 2007. OWNERS MAY CONTACT SUBARU AT 1-800-782-2783.
Airbag
Summary
On certain vehicles, the wiring harness for the airbag occupant detection system in the front passenger seating position might have been pinched during vehicle assembly. Pinching of the wiring harness between the floor cross member and the seat mounting bracket could result in an electrical short which would blow the circuit fuse. If this happens, the passenger airbag would be unable to deploy during a crash, leaving the seat occupant susceptible to increased injuries. Correction: Dealers will inspect and, if required, repair wiring damage.
Electrical
Summary
On certain vehicles, a wire for the Immobilizer Control Module was pinched between the two halves of the ICM security cover. As a result, the engine may not start, or may stall while driving. Correction: Dealers will inspect and, if necessary, repair damaged wiring.
Generated by Cardog • December 15, 2025
2006 Subaru Forester
Safety Recalls & Notices
5 Active Recalls
Requires attention
