2006 Buick Allure
Safety Recalls & Notices
We found 4 safety recalls for the 2006 Buick Allure. Recalls are sourced from both NHTSA (US) and Transport Canada databases. Contact your authorized Buick dealer to schedule free repairs.
Summary
On certain vehicles, the headlamp driver module (HDM) may not operate properly in high underhood temperatures. If the HDM is not operating correctly, the low-beam headlamps and daytime running lamps could fail to illuminate. Loss of daytime running lamps and low-beam headlamps could result in decreased driver's vision, as well as rendering the vehicle less visible to other motorists, which could result in a crash causing injury and/or property damage. Correction: Dealers will replace the headlamp relay (HDM) located in the underhood bussed electrical centre (UBEC). Note: this condition does not affect the high-beam headlamps, marker lamps, turn signals, or fog lamps. Note: This recall supersedes recall 2014-535.
Summary
On certain vehicles, the headlamp driver module (HDM) may not operate properly in high underhood temperatures. If the HDM is not operating correctly, the low-beam headlamps and daytime running lamps could fail to illuminate. Loss of daytime running lamps and low-beam headlamps could result in decreased driver's vision, as well as rendering the vehicle less visible to other motorists, which could result in a crash causing injury and/or property damage. Correction: Dealers will replace the headlamp driver module (HDM) with a new design HDM. Note: this condition does not affect the high-beam headlamps, marker lamps, turn signals, or fog lamps. Note: This recall is superseded by recall 2015365.
Summary
On certain vehicles, a defect in the ignition switch could allow the switch to move out of the "run" position if the key ring is carrying added weight or the vehicle goes off-road or is subjected to some other jarring event. If this were to occur, engine power, power steering and power braking would be affected, increasing the risk of a crash causing injury and/or damage to property. The timing of the key movement out of the “run” position, relative to the activation of the sensing algorithm of the crash event, may also result in the airbags not deploying in a subsequent collision, increasing the risk of injury. Correction: For each key, dealers will install two key rings and modify the key ring opening shape. Note: Until the correction is performed, all items should be removed from the key ring.
Summary
Certain vehicles equipped with remote start capability fail to comply with the requirements of CMVSS 208 - Occupant Restraint Systems. The safety belt reminder light for the driver's seating position does not illuminate after the ignition key is inserted and turned to the 'run' position following a remote start. As well, the audible chime for the driver's seating position will not sound if the driver and a front seat passenger enter the vehicle following a remote start, the passenger buckles his/her seatbelt within 25 to 33 seconds after the remote start, and the ignition key is then turned to the 'run' position. Note: This non-compliance condition has no affect on vehicle safety. Correction: Dealers will recalibrate the Sensing Diagnostic Module (SDM) to activate an enhanced seatbelt reminder feature, which repeats the chime and telltale cycles up to two times if the seatbelt is not buckled and if the vehicles speed is over 8 km/h. This enhanced feature is already activated on 2007 vehicles.
4 Active Recalls
Requires attention
2006 Buick Allure Recall FAQs
Common questions about recalls for this vehicle
Related Recall Checks
Compare recall history with competitors and alternatives to the 2006 Buick Allure.