Listed by NHTSA for this model year
4Possible recalls
2 Canadian (Transport Canada) records, shown separately below
4
Recalls
Dec 10, 2020
Most recent

Newest first. Many cover only part of a model year, so check your VIN with NHTSA or Porsche before booking a repair.

NHTSA · listed for this model year

Ohlins USA, Inc (Ohlins) is recalling certain Front Struts, part number POS 5N20. These struts were sold as part of Ohlins strut kits part number POZ MN02, intended for installation on 1999-2005 Porsche 911 Carrera 4 and 4S (generation 996), and 2001-2006 Porsche 911 Turbo / Turbo S (generation 996) and kit part number POZ MN05, intended for installation on 2005-2012 Porsche 911 Carrera 4 and 4S (generation 997), and 2006-2013 Porsche 911 Turbo / Turbo S (generation 997). The pin of the strut may experience excessive stress during maximum steering, possibly resulting breakage of the pin.

Potential consequence

If the pin fails, it will cause separation of the strut from the vehicle, affecting vehicle control and increasing the risk of a crash.

Remedy

Ohlins will notify owners, and dealers will request the return of all unsold kits containing the subject part from dealer/distributor inventory for a full refund. All owners who purchased one of the kits (POZ MN02 or POZ MN05) will receive replacement front struts (POS 5N20 or POS 5N21 - These parts are interchangeable), along with new top mount interface solutions, free of charge. The recall began December 22, 2020. Owners may contact Ohlins customer service at 1-800-336-9029.

20E091000 · 584 units in campaign · NHTSA

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

PORSCHE IS RECALLING CERTAIN MODEL YEAR 2011 911 SPEEDSTER AND 911 GTS RS 4.0; AND MODEL YEAR 2012 BOXSTER (INCLUDING S AND SPYDER); CAYMAN (INCLUDING S AND R); 911 CARRERA (INCLUDING S, GTS, 4, 4S, AND 4 GTS); 911 TARGA 4 AND TARGA 4S; AND 911 TURBO AND TURBO S MODELS MANUFACTURED FROM MAY 31, 2011, THROUGH JUNE 10, 2011. THERE IS A POSSIBILITY THAT THE MOUNTING HOLES IN THE SEAT BELT ANCHOR PLATES FITTED TO THE VEHICLE ARE TOO SMALL. IF THE HOLE DIAMETER IS TOO SMALL, THE ANCHOR PLATE MAY NOT BE ABLE TO ROTATE ABOUT THE FASTENING BOLT AS DESIGNED.

Potential consequence

SHOULD THIS OCCUR, THE SEAT BELT MAY NOT BE ROUTED OPTIMALLY AROUND THE OCCUPANT, OR MAY POTENTIALLY LOOSEN AT SOME POINT IN THE FUTURE INCREASING THE RISK OF INJURY DURING A CRASH.

Remedy

PORSCHE WILL NOTIFY OWNERS, AND DEALERS WILL INSPECT THE SEAT BELT ANCHORS AND, IF NECESSARY, REPLACE THE SEAT BELT. THE REPAIRS WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON SEPTEMBER 2, 2011. OWNERS MAY CONTACT PORSCHE AT 1-800-767-7243.

11V409000 · 235 units in campaign · NHTSA

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

PORSCHE IS RECALLING CERTAIN MODEL YEAR 2010-2011, 911 TURBO; TURBO S, 911 GT3, GT3 RS AND GT2 RS HIGH PERFORMANCE VEHICLES, MANUFACTURED FROM MAY 18, 2009 THROUGH SEPTEMBER 17, 2010, AND EQUIPPED WITH CENTER LOCKING HUB AND WHEEL ASSEMBLIES. OVER TIME THE HUBS CAN WEAR PREMATURELY.

Potential consequence

AS THE HUBS WEAR, THE WHEELS COULD LOOSEN, INCREASING THE RISK OF A CRASH.

Remedy

DEALERS WILL REPLACE THE CENTRAL LOCKING HUBS AND WHEELS WITH AN IMPROVED DESIGN, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JUNE 28, 2011. OWNERS MAY CONTACT PORSCHE AT 1-800-767-7243.

11V285000 · 1,702 units in campaign · NHTSA

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

Canadian records (Transport Canada) · 2

These are Transport Canada campaigns for 2011 Porsche 911 vehicles sold in Canada. A Canadian campaign may have no US counterpart, or one under a different number covering different vehicles. For a vehicle sold in the United States, go by the NHTSA listing above and NHTSA's VIN lookup.

2011 Porsche 911 recall questions

Related recall checks