1985 944

THE SHORT SECTION OF HIGH PRESSURE FUEL HOSE BETWEEN THE FUEL RAIL AND THE FUEL PRESSURE REGULATOR, WHICH RUNS ALONGSIDE THE INTAKE MANIFOLD, MAY BE SUBJECT TO HARDENING. IN THE EVENT THAT THIS LINE DOES HARDEN, FUEL LEAKS COULD DEVELOP BETWEEN THE HOSE AND METAL PIPE FITTINGS. LEAKING FUEL COULD IGNITE ON THE HOT EXHAUST SYSTEM AND LEAD TO AN ENGINE COMPARTMENT FIRE. CORRECTION: FUEL HOSE WILL BE REPLACED ON 924S, 944 AND 944 TURBO VEHICLES AND THE FUEL HOSE AND FUEL RAIL WILL BE REPLACED ON 944S VEHICLES.

1990051 · 2,527 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

THE HOSE MATERIAL USED IN THE SHORT SECTION OF THE HIGH PRESSURE FUEL LINE HOSE, BETWEEN THE FUEL RAIL AND FUEL PRESSURE REGULATOR, IS SUBJECT TO HARDENING, AND COULD CAUSE FUEL LEAKS BETWEEN THE HOSE AND THE METAL PIPE FITTINGS.

90V061000 · 53,427 units in campaign · NHTSA

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

THE FUEL SUPPLY HOSE TO THE PRESSURE DAMPER IN THE ENGINE COMPARTMENT MAY DEVELOP A LEAK BETWEEN THE FLEX HOSE AND THE THREADED CONNECTOR DUE TO IMPROPER CRIMPING OF THE FITTING. THIS WILL CAUSE THE FUEL PRESSURE IN THE INJECTION SYSTEM TO DROP, RESULTING IN ENGINE STALLING. A STALLED VEHICLE COULD POSE A THREAT TO TRAFFIC SAFETY.

1985040 · 195 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

FUEL HOSE MAY BE DAMAGED DUE TO TOO MUCH PRESSURE IN CRIMPING THE HOSE END FITTING. CONSEQUENCE OF DEFECT: A FUEL LEAK COULD DEVELOP WHICH COULD CAUSE A LOSS IN SYSTEM PRESSURE AND ENGINE STALLING. ALSO, FUEL VAPORS IN THE ENGINE COMPARTMENT COULD BE IGNITED BY A SPARK AND CAUSE A FIRE.

85V039000 · 1,530 units in campaign · NHTSA

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

VEHICLES WITH CRUISE CONTROL. UNDER CERTAIN CONDITIONS THERE COULD BE INSUFFICIENT CLEARANCE BETWEEN THE METAL BUSHING AND THE SHAFT OF THE CRUISE CONTROL LINKAGE. ALSO, THE LINKAGE POINTS WERE NOT LUBRICATED DURING ASSEMBLY. WITH THE CRUISE CONTROL SWITCHED ON, THE CONTOL LINKAGE COULD BIND CAUSING THE ACCELERATOR PEDAL TO STICK ON THE DEPRESSED POSITION. THIS COULD RESULT IN LOSS OF CONTROL AND VEHICLE CRASH.

1985026 · 200 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

METAL BUSHINGS FOR THE CRUISE CONTROL LINKAGE ARE SUBJECT TO CORROSION DUE TO WEATHER CONDITIONS. ALSO, THERE IS NOT ENOUGH CLEARANCE BETWEEN THE BUSHINGS AND THE SHAFT; AND THE LINKAGE POINTS WERE NOT LUBRICATED. THUS, CRUISE CONTROL LINKAGE CAN BIND, CAUSING THE ACCELERATOR PEDAL TO STICK IN A DEPRESSED POSITION. CONSEQUENCE OF DEFECT: THE VEHICLE, WITHOUT WARNING, WOULD CONTINUE AT SET SPEED AND CAN'T BE REDUCED. THIS COULD RESULT IN LOSS OF CONTROL AND AN ACCIDENT.

85V023000 · 5,916 units in campaign · NHTSA

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer