Mazda
Cx-9

1. What component or system failed or malfunctioned, and is it available for inspection upon request? ANSWER: Engine failure due to overheating. 2. safety & indicators: ANSWER: During evening rush hour traffic on a 3 lane highway my car went into a form of engine power saving mode while i had children in the vehicle; this was almost catastrophic form my family and the other vehicles around me. there was NO warning. there were no previous issues with my vehicle, this was unexpected. 3. technician review: this is a known issue with no warning: The technician inspected your vehicle and found a concerning issue with the engine overheating. They scanned the vehicle and found a trouble code P111A, indicating the engine coolant reached a temperature of 251.6 degrees Fahrenheit, forcing the engine into limp mode. Based on their experience, the technician believes the engine likely reached much higher temperatures, potentially causing internal damage to the engine block. After a thorough inspection, they found no external coolant leaks, but upon using a digital borescope, they discovered evidence of coolant entering and being burned off in Cylinder 3. Given the severity of the issue, the technician recommends replacing the entire engine to ensure the long-term reliability and extended life of your vehicle. Services completed: - Scanned vehicle and found trouble code P111A - Inspected engine and found no external coolant leaks - Used digital borescope to inspect cylinders and found coolant entering Cylinder 3 Recommendations: - Replace the entire engine

I am reporting a serious safety issue involving a defective suspension part (lower control arm) manufactured by Dorman and purchased from an online auto parts retailer. On October 7, 2024, I ordered a Dorman lower control arm for my vehicle and had it professionally installed on November 7, 2024 at Johnston and Magwood Wheels & Tires. On November 8, 2024, at approximately 5:40 p.m., while I was driving and made a hard brake, I suddenly lost steering control and my front left wheel collapsed. Fortunately, I was the only one in the car and managed to avoid an accident. My vehicle had to be towed to a nearby shop (Kal Tire) and was later sent back to the original shop for further inspection. On November 12, technicians confirmed that the newly installed lower control arm had failed, which caused serious damage to the suspension. I paid $1,774.10 in repairs in order to make the car safe to drive again. This is extremely dangerous — if I had been driving on a highway or with passengers, it could have resulted in a major accident or injuries. When I contacted the retailer about the warranty, they only offered to refund the part itself and refused to take responsibility for the damages caused by this defective product. I believe this part should be investigated for safety defects. When I searched online, I noticed Dorman has had similar recalls on control arms, which makes me even more concerned. I am reporting this incident to NHTSA in hopes that you will look into this part to protect public safety.

While driving on highway I get a message on my dashboard "High Engine Temperature/Engine Output may be limited" warning message. I pullover and see that the cooland is low. I wait for thee car to cool down and fill with coolant. After 5 minutes of driving, get the same message on dash. I had car towed to Martin Mazda in Delaware. Diagnosis is that I need a new EGR valve and new engine $13,000. How coincidental it has the same symptoms as described in TSB and manifests itself differently and not covered? I even had my vehicle towed to John Kennedy Mazda in Pennsylvania and diagnosis is coolant is leaking into my engine. Too much of a coincidence and I am not the only Mazda owner experiencing this. My car is part of the VIN for the Mazda Powertrain Warranty Extension Technical Service Bulletin 01-002/23 (Feb. 10, 2023). The Mazda Techs are trained to not diagnose as such not to be covered under the warranty due to the enormous economic strain it will put on Mazda corporation. Mazda gets around the class action suits by offering the Warranty Extension but not honoring it. Mazda needs to own up to their mistake and turn this Warranty Extenions TSB into an actual Recall. Will it take an actual stall of the Mazda affected vehicle on the highway causing deaths for some corrective action to be taken?

Vehicle jumps while driving. And sometimes stalls.

Failed water pump, blown head gasket, major coolant leak, and warped head causing the vehicle to overheat and die when coming to a stop. Vehicle died when stopped in construction on a highway and we were nearly rear-ended. Vehicle never showed check engine light and temperature gauge never showed that vehicle was overheating but significant damage was caused to the engine from “excessive temperatures.” Failure of warning signals allowed us to continue driving the car with a significant engine issue. Now the entire engine needs replaced at only 83,000 miles. Car was diagnosed by licensed independent repair shop. Additionally, front struts went out at approximately 40,000 miles making the car wobble at higher speeds. Was inspected and replaced by dealership.

Car coolant warning light came on for a short time 5 min after starting car, then would go off. During severely cold days it would come on then go off once the car was warm. On 2/25/25 the coolant warning light appeared and stayed on. The car made loud rickety noise, as it warmed up. After driving 2 miles the car coolant light turned red and began blinking. An alert appeared saying car over heating. The car was stopped and smoke came out of the car. The car leaked blue/greenish fluid. Overnight the car cooled. The next day the car continued making loud rickety noise driving to dealership. Dealership would not honor extended warranty for coolant leaks at the cylinder. The water pump cracked, with coolant leak also causing the cylinder to crack and leak oil. Dealership is suggesting total engine replacement. The car has gone through its normal servicing with no reported issues of coolant leak or depletion. The engine overheated in a span of 2 miles after being parked for 8 hours. The car was

I was backing out of a parking spot while watching the backup camera when I felt a bump as if I hit something but the camera was showing I have enough space to the cars behind me. It turns out the backup camera image was frozen on the display and I had hit a car parked behind my car. Please investigate and make the manufacturer solve problems with the hardware or the software. Make sure the display shows a warning when the camera fails and the vehicle drives backwards. There may be children behind the car. Shifting into park and then into reverse again caused the camera to work correctly.

2019 CX-9 GT, 30K miles, in August found coolant leaking under the car. This was 5 months past the warranty (but only 30K miles!). After doing research online, I found this is a massively common issue with all engines from several years encompassing 2019, where the coolant leaks due to a cracked cylinder head. There is a TSB from Mazda, which requires replacement of the engine, once the crack is developed. I immediately called Mazda corporate on 8/15/2024 and opened the case with them. They said they can try to assist, but first I have to take the car to the dealer for diagnosis of the problem. Had to wait 2 weeks, then leave the car, they did a full inspection and confirmed cracked cylinder head. Dealer opened up claim with Mazda (which apparently is separate from the case I made when I called the corporate). I had to go back because Mazda warranty dept. was asking the dealer to prove the engine was overheating, which it hasn't yet, because I kept adding coolant, so the engine never overheated. But the dealer lowered the coolant and had the engine overheat a little bit just to generate the computer code the warranty dept was requiring. This itself was an unnecessary additional potentially damaging scenario, completely unnecessary when the crack in the cylinder head was already found, and the coolant leak is clearly present. After all this, Mazda lowered their original quote from $10K to $6K and expect me to pay this to replace the engine. I called the corporate (customer relations) many times, but they said if the warranty dept. decided this, they cannot change it. And there's no way to talk to warranty dept. directly (not customer facing). We purchased a brand new factory assembled car for well over $40K. Due to a very common, Mazda acknowledged, engine manufacturing defect, the major component of the vehicle, its engine, requires replacement at only 30K miles! This is NOT a reasonable expectancy when purchasing any vehicle.