Saab · 1999–2011
9-5 Recalls
6 known recalls affecting the Saab 9-5 (1999–2011). Enter your VIN to check if your specific vehicle is affected, or browse by model year below.
Saab 9-5 Recalls
Summary
On certain vehicles, the driver frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture, which could allow fragments to be propelled toward vehicle occupants, increasing the risk of injury. This could also damage the airbag module, which could prevent proper deployment. Failure of the airbag to fully deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Correction: Dealers will replace the driver airbag inflator on Saab 9-3 and 9-5 vehicles and replace the driver airbag module on Saturn Astra vehicles.
Summary
On certain vehicles, the fuel pump retaining tabs holding the fuel lines were damaged during production. Over time, this could cause the fuel lines to loosen from the pump resulting in fuel leakage. If an ignition source were present, the fuel may ignite resulting in a vehicle fire. Correction: Dealers will install a bracket that will secure the fuel lines to the fuel pump even if the plastic retaining tabs should break.
Summary
Certain 2000-2002 Saab 9-3 and 9-5 model vehicles equipped with 4-cylinder gasoline engines, and 2001-2003 9-5 models equipped with 6-cylinder gasoline engines may experience overheating and burnout of the Isolated Gated Bipolar Transistor (IGBT) within the Ignition Discharge Module (IDM) due to increased susceptibility to electrical loads. Overheating of the IGBT occurs most often at engine start-up but may also occur while the engine is running. When the IDM fails on a 4-cylinder while it is running, the engine may stall without warning, with no ability to be restarted. When the IDM fails on a 6-cylinder engine while it is running, the driver will initially experience reduced power and rough operation because the engine will only be running on three cylinders. The check engine light will flash. If the driver continues, unburnt fuel in the exhaust can cause thermal damage to the catalytic converter. The engine may stall and not restart. Correction: Dealers will inspect and, if required, replace the IDM.
Summary
Certain vehicles do not comply with the requirements of CMVSS 210. The required markings for the child tether anchorage hooks are missing in the luggage compartment area. Correction: Dealers will install the required adhesive label to the luggage compartment loading floor in the near vicinity of the three anchorage hooks.
Summary
On certain vehicles, when changing back and forth between alloy and steel wheels (as for winter tires), rust and other contaminates may build up on the mating surface of the wheel hubs. If this surface is not cleaned between wheel changes, uneven torque forces may cause wheel bolts to fracture. Although this is most likely to happen during wheel change service, it is possible that the bolts may break later while the vehicle is being driven. Correction: Dealer will clean the hub and reinstall the wheel with improved bolts and attached washers that will eliminate the clamping force reduction.
Summary
Certain passenger vehicles. The steering knuckle castings may have been contaminated during the casting process. These knuckles can break resulting in possible loss of steering control. Correction: dealers will inspect the steering knuckle for the casting bunch number. If the knuckle belongs to the defective batch, the steering knuckle will be replaced
Related Recall Checks
Check recalls for specific Saab 9-5 model years