2004 Nissan Xterra
Safety Recalls & Notices
5 Active Recalls
Requires attention
Steering
Summary
On certain vehicles, corrosion may form in the lower steering column joint and limit the movement of the joint. Limited movement of this joint may create excessive load on the lower steering column shaft and, if the vehicle continues to be driven in this condition, may lead to cracking of the shaft during low speed manoeuvres that require large steering inputs. In an extreme case, the shaft may break which would result in loss of steering control and could result in a crash. Correction: Dealers will replace the affected column shafts and joints.
STEERING:COLUMN
Summary
NISSAN IS RECALLING CERTAIN MODEL YEAR 2002-2004 FRONTIER VEHICLES MANUFACTURED FROM JULY 9, 2001 THROUGH OCTOBER 20, 2004, AND MODEL YEAR 2002-2004, XTERRA VEHICLES MANUFACTURED FROM JULY 9, 2001, THROUGH JANUARY 6, 2005. OVER TIME CORROSION MAY FORM IN THE LOWER STEERING COLUMN JOINT AND LIMIT MOVEMENT OF THE JOINT. THE LIMITED MOVEMENT OF THIS JOINT MAY CREATE EXCESSIVE LOAD ON THE LOWER STEERING COLUMN SHAFT. IF THE VEHICLE CONTINUES TO BE DRIVEN IN THIS CONDITION, IT MAY LEAD TO CRACKING OF THE SHAFT DURING LOW SPEED MANEUVERS THAT REQUIRE LARGE STEERING INPUTS.
Potential Consequence
THE SHAFT MAY BREAK WHICH COULD RESULT IN LOSS OF STEERING CONTROL DURING THESE LOW SPEED MANEUVERS INCREASING THE RISK OF A CRASH.
Remedy
THE STEERING COLUMN SHAFT AND JOINT WILL BE REPLACED WITH A SHAFT OF A DIFFERENT DESIGN. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE RECALL BEGAN ON DECEMBER 13, 2010. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
Engine
Summary
On certain vehicles the Intelligent Power Distribution Module (IPDM) assembly contains an Engine Control Module (ECM) relay that has a diode for electrical current noise reduction. The ECM relay may allow silicon vapor to form and over time the silicon evaporates from the diode molding which causes silicon oxide to develop on the ECM relay contact due to arcing. In certain instances, this oxidation could cause engine performance issues (hesitation, rough engine idle, slow start/no-start condition), and engine stalling at low engine speeds which may result in a crash. Correction: Dealers will replace the Engine Control Module (ECM) relay.
EQUIPMENT
Summary
CERTAIN HOPKINS AFTERMARKET TRAILER BRAKE CONTROL CONNECTION HARNESSES SOLD FOR USE ON CERTAIN MODELS OF NISSAN VEHICLES WHICH ARE LISTED ABOVE. THE INTERNAL PART NUMBERS WITHIN HOPKINS ARE: 1010476025, 1040376025, 1110476025, 1170376025, 1290376025, 1010476035, 1040376035, 1110476035, 1170376035, AND 1290376035. A WIRE MAY HAVE BEEN PLACED IN AN INCORRECT POSITION IN THE ELECTRICAL CONNECTOR HOUSING. THIS RESULTS IN AN INCORRECT ROUTING OF WIRES BETWEEN THE TRAILER BRAKE CONTROLLER AND THE TOWING VEHICLE WIRING SYSTEM.
Potential Consequence
THIS HARNESS WOULD RESULT IN POWER FROM THE TRAILER BRAKE CONTROLLER GOING TO THE TOWING VEHICLE DASH LIGHT CIRCUIT RATHER THAN THE TRAILER BRAKES. THIS RESULT WOULD BE THE LACK OF TRAILER BRAKING WHEN THE TOWING VEHICLE BRAKES WERE APPLIED. IT WOULD ALSO RESULT IN THE TOWING VEHICLES DASH LIGHTS BEING ACTIVATED WHEN THE VEHICLE BRAKES WERE APPLIED. THE FAILURE OF THE APPLICATION OF THE TRAILER BRAKE COULD RESULT IN REDUCED ABILITY TO STOP AND CONTRIBUTE TO A POSSIBLE CRASH.
Remedy
HOPKINS WILL NOTIFY OWNERS AND REPLACE THE ORIGINAL HARNESS WITH A REVISED HARNESS FREE OF CHARGE. THE RECALL BEGAN AUGUST 17, 2007. OWNERS CAN CONTACT HOPKINS AT 800-835-0129.
TRAILER HITCHES
Summary
ON CERTAIN SPORT UTILITY VEHICLES, THE ACCESSORY TOW HITCH ATTACHMENT BOLTS MAY NOT HAVE BEEN TIGHTENED TO THE PROPER SPECIFICATION.
Potential Consequence
THIS COULD CAUSE THE TOW HITCH TO LOOSEN OR SEPARATE FROM THE VEHICLE WHICH COULD RESULT IN A CRASH WITHOUT WARNING.
Remedy
DEALERS WILL TIGHTEN THE TOW HITCH. THE RECALL BEGAN ON JANUARY 3, 2005. OWNERS SHOULD CONTACT NISSAN AT 1-800-647-7261.
Generated by Cardog • December 11, 2025
2004 Nissan Xterra
Safety Recalls & Notices
5 Active Recalls
Requires attention
