1993 Nissan Altima
Safety Recalls & Notices
4 Active Recalls
Requires attention
SUSPENSION
Summary
RIDE CONTROL IS RECALLING CERTAIN FRONT STRUT MOUNTS BRANDED AS GABRIEL RIDE CONTROL OR ARVINMERITOR, P/NOS. 142435, 142193, 142305, 142303, SOLD AS REPLACEMENT EQUIPMENT FOR THE VEHICLES LISTED ABOVE. THE AFFECTED FRONT STRUT MOUNTS DID NOT CONTAIN A WELD JOINT BETWEEN THE BEARING HOUSING AND THE RATE PLATE.
Potential Consequence
THE ABSENCE OF THE WELD CAN ALLOW THE STRUT TO COME OUT OF ITS MOUNTING POSITION UNDER CERTAIN EXTREME DRIVING CONDITIONS WHICH COULD CAUSE DAMAGE TO SURROUNDING VEHICLE COMPONENTS INCREASING THE RISK OF A CRASH.
Remedy
RIDE CONTROL WILL NOTIFY OWNERS OF RECORD AND REPLACE THE AFFECTED PARTS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MARCH 15, 2010. OWNERS MAY CONTACT RIDE CONTROL AT 1-248-458-1396.
EXTERIOR LIGHTING
Summary
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
Potential Consequence
WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.
Remedy
PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.
VEHICLE SPEED CONTROL
Summary
ENGINE MOVEMENT CAN BE TRANSMITTED TO THE AIRFLOW METER/FILTER HOUSING AND SUPPORT BRACKET, WHICH IS MOUNTED IN THE ENGINE AIR DUCT, CAUSING THE THROTTLE CABLE HOUSING TO PULL OUT OF THE CABLE GUIDE. THIS MAY PREVENT THE THROTTLE FROM RETURNING TO THE IDLE POSITION WHEN THE GAS PEDAL IS RELEASED.
Potential Consequence
IF THIS WERE TO OCCUR WHILE THE VEHICLE IS IN MOTION, LOSS OF THROTTLE CONTROL COULD RESULT IN AN ACCIDENT.
Remedy
NISSAN WILL REPOSITION THE THROTTLE CABLE HOUSING IN THE SUPPORT BRACKET TO PROVIDE ADDITIONAL SLACK FOR ENGINE MOVEMENT. A RUBBER STOPPER WILL BE CLAMPED TO THE CABLE TO MAINTAIN THE CORRECT POSITION FOR THE CABLE AT THE SUPPORT BRACKET. IN ADDITION, THE THROTTLE CABLE WILL BE TESTED FOR PULL OUT RESISTANCE FROM THE GUIDE IN THE EVENT THE CABLE WAS DAMAGED. THE THROTTLE ASSEMBLY WILL BE REPLACED, IF NECESSARY.
Engine
Summary
ENGINE MOVEMENT MAY RESULT IN THE THROTTLE CABLE HOUSING BEING PULLED OUT OF THE CABLE GUIDE. THIS COULD PREVENT THE THROTTLE FROM RETURNING TO THE IDLE POSITION WHEN THE ACCELERATOR PEDAL IS RELEASED RESULTING IN THE POSSIBILITY OF A VEHICLE CRASH. CORRECTION: THROTTLE CABLE HOUSING WILL BE REPOSITIONED TO PROVIDE SLACK FOR ENGINE MOVEMENT. THROTTLE CABLE ASSEMBLY WILL BE REPLACED IF NECESSARY.
Generated by Cardog • December 11, 2025
1993 Nissan Altima
Safety Recalls & Notices
4 Active Recalls
Requires attention
