Safety Recalls & Notices
Requires attention
On certain vehicles, a defect in the ignition switch could allow the switch to move out of the "run" position if the key ring is carrying added weight or the driver unintentionally bumps the ignition key with their knee. An unintended change in ignition switch position while driving may result in loss of engine power, power steering, and braking assist, increasing the risk of a crash and disabling one or more of the vehicle’s safety features including the frontal airbags. Correction: Dealers will replace the ignition switch and lock cylinder. Important note: Until the correction is performed, drivers should adjust their seat to allow clearance between their knee and the ignition key, and remove all items from the key ring.
This defect can affect the safe operation of the airbag system. Until this recall is performed, drivers should adjust their seat to allow clearance between the driver's knee and the ignition key, and remove all items from their key ring, leaving only the vehicle key. Chrysler Group LLC (Chrysler) is recalling certain model year 2005-2007 Jeep Grand Cherokee vehicles manufactured February 11, 2004, to July 5, 2007, and 2006-2007 Jeep Commander vehicles manufactured January 31, 2005, to July 5, 2007. In the affected vehicles, the driver may accidentally hit the ignition key with their knee, unintentionally knocking the key out of the run position, turning off the engine.
If the ignition key inadvertently moves into the OFF or ACCESSORY position, the engine will turn off, which will then depower various key safety systems including but not limited to air bags, power steering, and power braking. Loss of functionality of these systems may increase the risk of crash and/or increase the risk of injury in the event of a crash.
Chrysler will notify owners, and dealers will replace the ignition switch, free of charge. Chrysler sent interim notifications to owners in September 2014. The recall began on October 9, 2015. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is P41.
On certain vehicles equipped with a full-time four-wheel drive system, the transfer case controller could fail. This could cause the transfer case to shift into or through the neutral position, which may allow the vehicle to roll away, even with the transmission in the PARK position. Should the vehicle roll away, it could strike another vehicle, stationary object, or a bystander, causing property damage and/or personal injury. Correction: Dealers will reprogram the final drive controller with updated software.
Chrysler Group LLC (Chrysler) is recalling certain model year 2005-2010 Jeep Grand Cherokee vehicles manufactured February 11, 2004, through March 9, 2010; and 2006-2010 Jeep Commander vehicles manufactured January 31, 2005, through March 10, 2010. A transfer case electrical failure may result in an unintentional shifting of the transfer case into the neutral position.
If the vehicle shifts into neutral, it may roll away increasing the risk of a crash or personal injury.
Chrysler will notify owners, and dealers will reflash the final drive controller which governs the transfer case, with new software, free of charge. The recall began on August 15, 2013. Owners may contact Chrysler at 1-800-247-9753. Chrysler's recall campaign number is N23.
Chrysler Group LLC (Chrysler) is recalling certain model year 2005-2010 Jeep Grand Cherokee vehicles manufactured February 11, 2004, through March 9, 2010; and 2006-2010 Jeep Commander vehicles manufactured January 31, 2005, through March 10, 2010. A transfer case electrical failure may result in an unintentional shifting of the transfer case into the neutral position.
If the vehicle shifts into neutral, it may roll away increasing the risk of a crash or personal injury.
Chrysler will notify owners, and dealers will reflash the final drive controller which governs the transfer case, with new software, free of charge. The recall began on August 15, 2013. Owners may contact Chrysler at 1-800-247-9753. Chrysler's recall campaign number is N23.
On certain vehicles that were not equipped with a factory sunroof, the supplemental side airbag inflatable curtain may not position properly during inflation. The side curtain airbag will still timely deploy and meet and exceed applicable safety standards. Correction: Dealers will install a bracket and foam block behind the "B" pillar upper trim cover to improve side curtain airbag positioning in the event of a deployment. This action is a Customer Satisfaction Campaign and is not being conducted as per the requirements of the Motor Vehicle Safety Act.
ROCK KRAWLER IS RECALLING 44 PERFORMANCE SUSPENSION SYSTEMS SOLD AS AFTERMARKET EQUIPMENT FOR USE ON THE VEHICLE LISTED ABOVE. THESE SUSPENSION SYSTEMS WERE PRODUCED WITH GRADE 2 CARRIAGE BOLTS INSTEAD OF THE PROPER GRADE 5 CARRIAGE BOLTS. THE IMPROPER GRADE 2 CARRIAGE BOLTS COULD EXPERIENCE A LOSS OF CLAMPING FORCE FOR THE BOTTOM STRUT FORK.
THIS CONDITION COULD CAUSE A LOSS OF EFFECTIVE LIFT AND LOWERING OF THE AFFECTED VEHICLE, POSSIBLY CREATING THE DRIVER TO PANIC WHICH COULD POSSIBLY LEAD TO A VEHICLE CRASH.
ROCK KRAWLER WILL NOTIFY OWNERS AND PROVIDE A FREE REMEDY. THE SAFETY RECALL BEGAN ON OCTOBER 15. 2008. ALL THE AFFECTED UNTITS HAVE BEEN REMEDIED. OWNERS MAY CONTACT ROCK KRAWLER AT 1-518-270-9822.
On certain vehicles, software programmed into the Antilock Brake System (ABS) electronic control module may allow a momentary delay in braking when coasting up a hill during certain conditions. This could cause a crash without warning. Correction: Dealers will reprogram the ABS electronic control module with updated software.
ON CERTAIN SPORT UTILITY VEHICLES, THE SOFTWARE PROGRAMMED INTO THE ABS ELECTRONIC CONTROL MODULE MAY ALLOW A MOMENTARY DELAY IN BRAKING WHEN COASTING UP A HILL DURING CERTAIN CONDITIONS.
THIS COULD CAUSE A CRASH WITHOUT WARNING.
DEALERS WILL REPROGRAM THE ABS ELECTRONIC CONTROL MODULE WITH NEW SOFTWARE THAT PREVENTS THIS CONDITION FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 22, 2007. OWNERS MAY CONTACT CHRYSLER AT 1-800-853-1403.
On certain vehicles, the front brake calipers were improperly manufactured and could break under certain operating conditions. This could increase the vehicle's stopping distance and cause a crash with injury or death. Correction: Dealers will inspect and, if required, replace the front brake calipers.
ON CERTAIN SPORT UTILITY VEHICLES, FRONT BRAKE CALIPERS IN A CERTAIN LOT MAY HAVE BEEN MANUFACTURED FROM GRAY IRON INSTEAD OF DUCTILE IRON AS DESIGNED AND COULD FRACTURE WITHOUT WARNING.
THIS WOULD INCREASE THE VEHICLE'S STOPPING DISTANCE AND COULD CAUSE A CRASH.
DEALERS WILL INSPECT THE FRONT BRAKE CALIPERS TO SEE IF THEY FALL INTO THIS LOT AND, IF SO, WILL REPLACE THEM FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 22, 2007. OWNERS MAY CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
ON CERTAIN VEHICLES, THE ANTILOCK BRAKE SYSTEM (ABS) CONTROL MODULE SOFTWARE MAY CAUSE THE REAR BRAKES TO LOCK UP DURING CERTAIN BRAKING CONDITIONS.
THIS COULD RESULT IN A LOSS OF VEHICLE CONTROL AND CAUSE A CRASH WITHOUT WARNING.
DEALERS WILL REPROGRAM THE ABS ELECTRONIC CONTROL UNIT. THE RECALL BEGAN ON FEBRUARY 19, 2007. OWNERS MAY CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
On certain vehicles, the Anti-lock Brake System (ABS) control module software may cause the rear brakes to lock-up during certain braking conditions. This could result in a loss of vehicle control and cause a crash without warning. Correction: Dealers will reprogram the ABS electronic control unit.
Generated by Cardog • December 12, 2025
Safety Recalls & Notices
Requires attention