Safety Recalls & Notices
Requires attention
On certain vehicles, aftermarket batteries may leak electrolyte onto the ABS control module connector and compromise the sealing integrity of the connector. This may allow development of a high resistance short circuit in the connector, which could eventually lead to a fire. Correction: Dealer will inspect the ABS control module connector for electrolyte damage, and replace the connector as necessary. All affected vehicles will also have a shield installed to protect the connector from future battery electrolyte leakage.
Certain Ram trucks equipped with a diesel engine. The potential is for the throttle control linkage joints to corrode and cause the throttle to bind or stick, which could result in a loss of throttle control. Correction: Dealers will replace the rod ends and ball studs.
On certain vehicles, impacts directly on the cover of the airbag electronic control module (AECM) located under the driver's seat could cause the airbag to deploy inadvertently. These impacts can be caused by tossing items under the driver's seat. Correction: Airbag control module will be replaced with a current production module that incorporates revised hardware and software changes.
On certain vehicles, the driver's side front power seat may not have adequate structural strength. The seat attaching welds were not made to specification, and as a result, the seat attachment strength is compromised. Correction: The driver's side power front seat riser will be replaced with a riser that is magnesium inert gas (mig) welded.
VEHICLE DESCRIPTION: PASSENGER VEHICLES BUILT WITH POWER SEAT OPTION. THE DRIVER'S SIDE FRONT SEAT ATTACHING RISER WELDS WERE NOT CORRECT.
THE SEAT ATTACHMENT STRENGTH WOULD NOT BE SUFFICIENT IN THE EVENT OF A VEHICLE CRASH INCREASING THE RISK OF PERSONAL INJURY.
DEALERS WILL REPLACE THE DRIVER'S SIDE POWER FRONT SEAT RISE WITH A RISER THAT WAS MIG WELDED.
Generated by Cardog • December 12, 2025
Safety Recalls & Notices
Requires attention