2008 Bmw 6 Series
Safety Recalls & Notices
4 Active Recalls
Requires attention
ELECTRICAL SYSTEM:12V/24V/48V BATTERY:CABLES
Summary
BMW IS RECALLING CERTAIN MODEL YEAR 2004-2010 5-SERIES, MODEL YEAR 2004-2010 6-SERIES, MODEL YEAR 2006-2010 M5, AND MODEL YEAR 2007-2010 M6 VEHICLES. THE INSULATED BULKHEAD CONNECTOR FOR THE POSITIVE BATTERY CABLE MAY HAVE BEEN INCORRECTLY ATTACHED TO THE TRUNK FLOOR PANEL, WHICH CAN LEAD TO A LOOSENING OF THE BOLT CONNECTION. AS IT LOOSENS, AN INCREASE IN ELECTRICAL RESISTANCE AT THIS CABLE CONNECTION IS POSSIBLE AND COULD CAUSE THE CABLE CONNECTION TO OVERHEAT.
Potential Consequence
OVERHEATING COULD LEAD TO A FIRE, EVEN WHILE THE VEHICLE IS NOT IN USE. AS A PRECAUTION, OWNERS ARE ADVISED TO PARK OUTSIDE UNTIL THE REMEDY HAS BEEN MADE.
Remedy
BMW WILL NOTIFY OWNERS, AND DEALERS WILL INSPECT AND SECURE THE BATTERY BOLT CABLE CONNECTION AS NECESSARY, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON APRIL 30, 2012. OWNERS MAY CONTACT BMW CUSTOMER RELATIONS AND SERVICES AT 1-800-525-7417.
Electrical
Summary
On certain vehicles, the insulated bulkhead connector (used to join the two halves of the positive battery cable) may have been incorrectly installed during vehicle assembly. Over time, the bolt connection could loosen, which would increase electrical resistance. In addition, an incorrectly insulated bulkhead connector could allow humidity to accumulate at this location, causing current leakage. These issues could cause the cable connection to overheat, which could result in a vehicle fire causing property damage and/or personal injury. Correction: Dealers will inspect and, as necessary, secure the insulated bulkhead connector. In addition, protective grease will be added to the area and the plastic battery positive terminal cover will be replaced.
Brakes
Summary
On certain vehicles, a check valve in the brake vacuum pump may leak a small amount of lubricating oil. Over time, this could result in contamination of the brake booster. Loss of brake power assist could occur which, in conjunction with traffic, road conditions, and driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the brake booster and master cylinder. Additionally, the brake vacuum line (including the check valve) will be replaced to eliminate the possibility of oil reaching the brake booster.
SERVICE BRAKES, HYDRAULIC:POWER ASSIST:VACUUM
Summary
BMW IS RECALLING CERTAIN MODEL YEAR 2004-2010 5-SERIES, 6-SERIES, AND MODEL YEAR 2002-2008 7-SERIES VEHICLES. A CHECK VALVE OF THE BRAKE VACUUM PUMP MAY LEAK A SMALL AMOUNT OF LUBRICATING OIL. OVER TIME THIS COULD RESULT IN CONTAMINATION OF THE BRAKE BOOSTER.
Potential Consequence
POWER ASSIST BRAKING PERFORMANCE COULD BE ADVERSELY AFFECTED. IN EXTREME CASES THERE COULD BE A COMPLETE LOSS OF POWER ASSIST BRAKING. AN UNEXPECTED REDUCTION OR LOSS IN POWER BRAKING ASSIST MAY INCREASE THE RISK OF A CRASH.
Remedy
BMW WILL NOTIFY OWNERS AND DEALERS WILL REPAIR THE VEHICLES FREE OF CHARGE. THE SAFETY RECALL BEGAN ON NOVEMBER 24, 2010. OWNERS MAY CONTACT BMW AT 1-800-525-7417.
Generated by Cardog • December 15, 2025
2008 Bmw 6 Series
Safety Recalls & Notices
4 Active Recalls
Requires attention
