Issue: This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones. Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act. Safety Risk: Glass that breaks in to large pieces could create a risk of injury. Corrective Actions: The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.

2019420 · 5,327 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

Issue: On certain vehicles, there could be a reduction in power brake assist due to a decrease in output from the vacuum pump. This could cause a hard brake pedal and an increase in brake pedal effort to stop the vehicle. Safety Risk: A sudden increase in brake pedal force could lead to an increase in stopping distance. This could increase the risk of a crash. Corrective Actions: The company will notify owners by mail and instruct them to take their vehicle to a dealer to reprogram the electronic brake control module.

2019324 · 310,121 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

Certain vehicles may be equipped with rear seat belt retractors that do not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 208 - Occupant Protection in Frontal Impacts. The automatic-locking retractors (ALR) of the rear seat belts may not switch to a locked position when the seat belt is fully pulled out of the retractor. If used to secure a child seat, a seat belt that is not properly locked could increase the risk of injury to the child in the event of a crash. Correction: Dealers will inspect the rear seat belt retractors and replace them if necessary. Note: If the ALR is not working properly, a child seat should not be installed using the vehicle seat belt until this recall is completed.

2018535 · 780 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer