On certain vehicles, there is a risk that some drivers may bump the ignition key with their knee and unintentionally move the key from out of the "run" position. If this were to occur, engine power, power braking and power steering would be affected, which would unexpectedly increase steering and brake pedal effort, potentially increasing stopping distances and the risk of a crash causing injury and/or damage to property. The timing of the key movement out of the "run" position, relative to the activation of the sensing algorithm of the crash event, may also result in the airbags not deploying in a subsequent collision, increasing the risk of injury. Correction: Dealers are to remove the key blade from the original flip key/transmitter assemblies provided with the vehicle, and provide two new keys and two key rings for every original key. Important note: Until the correction is performed, drivers should adjust their seat and steering column to allow clearance between their knee and the ignition key.

2014273 · 30,927 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

On certain all-wheel-drive vehicles, a loss of grease from the centre constant velocity (CV) joint can over time result in vibrations of the propeller shaft and these vibrations could be transferred to the rollover sensor located on the floor above it. The signal produced by the vibrations in the rollover sensor may result in an unwarranted deployment of the curtain airbags creating a risk of injury to the occupants of the vehicle. Correction: Dealers are to replace the rear propeller shaft assembly.

2014244 · 790 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer