On certain vehicles, due to a manufacturing defect the start/stop button could stick inside of its housing. If this occurs, vibration could cause the electrical components inside the button to contact repeatedly in quick succession and initiate the emergency engine shut off procedure while the vehicle is in motion. This could result in increased steering and braking effort, a loss of motive power and would disable the supplemental restraint systems (SRS), increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and repair defective start/stop switch as necessary.

2015282 · 841 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

On certain vehicles, the fuel pressure sensor connected to the engine fuel delivery rail may not have been sufficiently tightened during vehicle assembly. Should the pressure sensor loosen, fuel could leak past a gasket used in the connection between the sensor and the rail. Fuel leakage, in the presence of an ignition source, could result in a fire causing property damage and/or personal injury. Correction: Dealers will inspect the pressure sensor and tighten to specification. Note: This is an expansion of recall 2012-074. Vehicles that were repaired under the previous campaign are not affected because that remedy would have corrected the subject condition.

2014539 · 10,434 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer