On certain vehicles, a defect in the ignition switch could allow the switch to move out of the "run" position if the key ring is carrying added weight or the vehicle goes off-road or is subjected to some other jarring event. If this were to occur, engine power, power steering and power braking would be affected, increasing the risk of a crash causing injury and/or damage to property. The timing of the key movement out of the “run” position, relative to the activation of the sensing algorithm of the crash event, may also result in the airbags not deploying in a subsequent collision, increasing the risk of injury. Correction: For each key, dealers will install two key rings and modify the key ring opening shape. Note: Until the correction is performed, all items should be removed from the key ring.

2014246 · 186,013 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

On certain vehicles equipped with a V8 engine, the starter or alternator cable may contact the power steering return line. If either the starter or alternator cable contacts the power steering return line, the cable could wear through the line, cause a power steering fluid leak and a loss of power steering assist. The contact may also wear the cable protective wrap, conduit, and wire insulation, so there is metal to metal contact. This could result in battery drain and if arcing occurs due to engine vibration and roll, it may burn a hole in the return line and allow power steering fluid to leak and potentially ignite, resulting in a possible engine compartment fire. Correction: Dealers will secure and, if necessary, reroute the lines to prevent contact.

2010385 · 161 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer