On certain vehicles, over time, the flexible sensor mat of passenger airbag suppression system (PPS) within the passenger seat can bend and become damaged. If this were to occur, the damage can potentially cause the PPS module to suppress the front passenger airbag during a crash. If fault exists in the PPS system and the vehicle is involved in a crash where airbag deployment is warranted, the front passenger airbag may not deploy, which if an adult is occupying the passenger seat, could increase the risk of injury to the occupant. Correction: Dealers will inspect the PPS sensor mat for damage and add a reinforcement strip to the sensor mat if no damage is found. If damage is found, the PPS sensor mat will be replaced and reinforcement strips added. Note: If an active fault exists in the PPS system, the airbag malfunction-indicator lamp will illuminate and the passenger airbag telltale will indicate that the airbag is off. Additionally, the driver information center will display a “Service Airbag” message, and the audio system will play an audible warning chime.

2017044 · 7,143 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

On certain vehicles, a defect may allow the ignition key to be removed from the ignition switch when the key is not in the "Off" position. This could result in unintended vehicle movement if the transmission is not in the "park" position (automatic transmission) or not in the reverse gear with the parking brake engaged (manual transmission), and increase the risk of a crash causing injury and/or property damage. Correction: Dealers will replace the ignition lock cylinder and/or ignition key.

2014126 · 367,972 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer

A safety defect may exist in ignition switches sold as service replacement parts. The defect could allow the ignition switch to unintentionally move from the “run” position to the “accessory” or “off” position with a corresponding reduction or loss of power. This risk may be increased if the key ring is carrying added weight or the vehicle goes off road or experiences some other jarring event. The timing of the key movement out of the “run” position, relative to the activation of the sensing algorithm of the crash event, may result in the airbags not deploying, increasing the potential for occupant injury in certain kinds of crashes. General Motors Canada will notify owners of all vehicles not affected by recalls 2014038 (GM number 13454) and 2014060 (GM number 14063) that could potentially have had the affected ignition switches installed during service or repair work. Owners will be instructed to take their vehicle to a dealer for inspection and repair if required. Note: Until the inspection is performed, all items should be removed from the key ring.

2014101 · 132,243 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorized dealer