2009 Peterbilt 388
NHTSA lists 15 recalls for the 2009 Peterbilt 388.
Confirm with NHTSA · Only the manufacturer confirms which recalls apply to one VIN.
15 recalls
- In the event that the Anti-lock Brake System (ABS) loses battery and/or ignition power to the controller, the dash warning light for the ABS may not illuminate to warn the driver of the loss of ABSNHTSADriver assistance › Electronic stability controlApr 6, 2020460,515 vehicles
- The affected trucks are equipped with Michelin 295/60R22.5 XZA-2 front tires that have a speed rating less than the vehicle is governed toNHTSATiresNov 9, 20151,876 vehicles
- The affected vehicles may be equipped with Tire and Rim Certification Labels that list a tire pressure below the actual correct amountNHTSALabelsMar 6, 2015213,230 vehicles
- The front axle tie rod end clamp bolts may be improperly torquedNHTSASteering › Tie rod assemblyFeb 24, 20155,141 vehicles
- The affected vehicles were built with 16.5" x 7" front drum brakes and Bendix ES-420 brake linings installed on front axles rated to carry between 20,001 and 22,000 lbs GAWR and larger SLR (20.5" to 21.5") tires, howe…NHTSABrakesMar 25, 2014474 vehicles
- The affected vehicles may be missing required information from the certification label, specifically the tag or pusher axle the gross axle weight rating, suitable tire and rim information, and recommended tire pressur…NHTSALabelsNov 25, 2013561 vehicles
- DEGRADATION OF A COMBUSTION TUBE WELD CAN CAUSE RADIAL HEAT IMPINGEMENT ON THE BODY WHICH MAY BURN THROUGH CERTAIN BODIES USED ON C15 ENGINESNHTSAEngineMar 24, 20115,831 vehicles
- THE OIL MODULE CENTRIFUGAL SPINNER FILTER CAP IN THE PACCAR MX ENGINE MAY BECOME LOOSE, POSSIBLY ALLOWING THE CAP TO COME OFF AND ENGINE OIL TO PARTIALLY DISCHARGE FROM THE OIL MODULE ONTO EXHAUST COMPONENTSNHTSAFuel system › StorageFeb 23, 20114,664 vehicles
- THE CIRCUMFERENTIAL WELD AROUND THE STEERING SHAFT TUBE THAT WELDS THE SPLINED TUBE TO THE NON-SPLINED TUBE MAY BE MISLOCATEDNHTSASteering › ColumnJul 2, 20109,697 vehicles
- MISLOCATION OF A CIRCUMFERENTIAL WELD MAY ALLOW THE SPLINED TUBE AND NON-SPLINED TUBE TO ROTATE RELATIVE TO ONE ANOTHER DURING A LOW SPEED, HIGH TORQUE TURN, POSSIBLY RESULTING IN A SEPARATION OF THE TWO TUBESNHTSASteering › ColumnJul 8, 20092,096 vehicles
- INADEQUATE STIFFNESS OF THE DIESEL PARTICULATE FILTER (DPF) BRACKET COULD RESULT IN SEPARATION OF THE DPF FROM THE CHASSISNHTSAEngine › DieselSep 23, 20084,883 vehicles
- THE SIZE 14 SERVICE CHAMBER OF CERTAIN FRONT AIR DISC BRAKES MAY HAVE BEEN CONTAMINATED WITH GREASE BETWEEN THE PISTON HEAD/PLATE AND THE DIAPHRAGMNHTSABrakes › DiscAug 25, 200886 vehicles
- THE MOLDED VALVE BODY HAS AN INCORRECT CORE PIN IN THE INJECTION MOLD CAUSING THE VALVE BODY TO BE OVERSIZED IN THE DOUBLE CHECK VALVE AREANHTSABrakes › ConventionalMar 21, 20081,043 vehicles
- THE PINTLE HITCH ASSEMBLIES MAY HAVE BEEN MANUFACTURED IN A MANNER RESULTING IN A REDUCTION OF FATIGUE STRENGTH OF THE PIVOT PINSNHTSAEquipment › Trailer hitchesMar 10, 2008318 vehicles
- CERTAIN DOOR LATCH ASSEMBLIES ON THESE VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NONHTSAStructure › DoorsFeb 7, 20086,169 vehicles