None listed. That is not a clearance for your vehicle: check your VIN with NHTSA or a BMW dealer.
NHTSA · listed for this model year
No recalls listed here in our latest copy of the authority's database. That is not a clearance: the manufacturer's VIN lookup is the record.
Canadian records (Transport Canada) · 6
These are Transport Canada campaigns for 1989 BMW 7 Series vehicles sold in Canada. A Canadian campaign may have no US counterpart, or one under a different number covering different vehicles. For a vehicle sold in the United States, go by the NHTSA listing above and NHTSA's VIN lookup.
On certain vehicles, failure of a cooling system component such as thermostat, water pump or fan belt can result in a significant increase in coolant temperature and system pressure. Increased system pressure could result the formation of a crack or separation of a seam in the heater core end piece which would cause hot coolant to be expelled from the heater core. This hot fluid could contact car occupants resulting in possible personal injury and/or fogging of the interior window surfaces. Correction: Radiator cap will be replaced with a new design cap in order to avoid buildup of excessive pressure in the cooling system.
1998197 · 22,752 units in campaign · Transport Canada
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
On certain 318I, 318IC, 318IS, 325IC, 325IS, 325IX, 525I, 535I, 735I and 735IL vehicles, the fuel feed hose could harden and "set" over time due to engine compartment temperatures. If this "setting" occurs, it is possible that seepage between the hose and fitting could result because the clamp cannot provide sufficient sealing force to compensate for the hardening of the hose. Fuel seepage, in the presence of an ignition source, could result in an engine compartment fire. Correction: fuel feed hoses and associated clamps will be replaced with ones of a new design.
1994096 · 10,661 units in campaign · Transport Canada
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
On certain 525I, 535I, 735I, 735IL and 750IL vehicles, the front seat center fold-down armrest may contact and damage the seatbelt buckle if the seat back is moved forward to an upright position while the armrest is locked in the down position (horizontal). If this occurs, the release button may be held in the down position, preventing the seatbelt from being latched during the buckle-up operation. Non-latching of the seatbelts will increase the risk of personal injury in the event of a crash. Correction: Front seat safety belt buckles will be replaced with shorter ones that are not susceptible to damage by contact with the armrest.
1990037 · 3,814 units in campaign · Transport Canada
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
Certain 750IL vehicles fail to comply with the requirements of CMVSS 1103 - Exhaust Emissions.
1989063 · 234 units in campaign · Transport Canada
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
Certain 750IL vehicles fail to comply with the requirements of CMVSS 1103 - Exhaust Emissions
1989062 · 277 units in campaign · Transport Canada
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
On certain 750IL vehicles, during the assembly process, the gas pedal may not have been properly attached to the floor pan. If the gas pedal is operated in a rough or erratice manner, it may become stuck between the gas pedal stop (on the floor pan) and the carpeting on the transmission tunnel. If this occurs, the pedal might not return fully to the idle position when the driver's foot is removed and loss of control could result. Application of the brake pedal will close the throttle on this model of vehicle. Correction: Accelerator pedal will be inspected and tightened to the floor is required. Also, a modified pedal stop will be installed.
1989046 · 329 units in campaign · Transport Canada
Applies only if the manufacturer confirms your VIN · repair by an authorized dealer
1989 BMW 7 Series recall questions
NHTSA lists no recalls for the 1989 BMW 7 Series in our latest copy of its database. That is not a clearance for your vehicle: campaigns can be issued at any time, and NHTSA's VIN lookup is the record. Transport Canada lists 6 Canadian campaigns for the Canadian-market model, shown separately.
Enter your VIN in NHTSA's recall lookup or BMW's own, or call a BMW dealer with your VIN. Cardog uses your VIN only to find the model year; the recalls shown here are listed for that model year and are not matched to your VIN.
Not necessarily. Transport Canada campaigns cover vehicles sold in Canada. For a vehicle sold in the United States, go by the NHTSA listing and NHTSA's VIN lookup.
Safety recall repairs are normally done at no charge by an authorized BMW dealer. The manufacturer's notice for each campaign sets out the remedy and any conditions, so confirm with the dealer when you book.
Once BMW's lookup or a dealer confirms a recall applies, book the repair with an authorized BMW dealer and bring your VIN. If the manufacturer's notice says not to drive the vehicle or to park it outside, follow that instruction. Parts can take time, so book early.
Follow the manufacturer's notice for that recall. Most allow normal driving until the repair; some tell owners to stop driving or to park outside until it is fixed. Cardog does not grade recalls by severity: the manufacturer's notice and your dealer are the source.
Manufacturers must notify owners they have on record. If you bought the vehicle used or have moved, update your details with BMW so notices reach you, and check NHTSA's lookup from time to time.
Related recall checks
Compare recall listings with alternatives to the 1989 BMW 7 Series.