2013 International Prostar
Transport Canada lists 16 recalls for the 2013 International Prostar.
Confirm with a International dealer · Only the manufacturer confirms which recalls apply to one VIN.
16 recalls
- On certain trucks, the backup lamps could be blocked and may not be visibleTransport CanadaLightingMay 18, 20231,764 vehicles
- On certain vehicles equipped with Navistar engines, the accelerator pedal position sensor could move on its mounting bracket if the pedal is depressed with excessive forceTransport CanadaEngineNov 18, 20151,466 vehicles
- The fifth wheel locking mechanisms could be susceptible to damage and/or wearTransport CanadaStructureSep 28, 2015188 vehicles
- A double battery (24 volt) jump start or electrical load dump could result in an overvoltage condition of the linear power module (LPM) which is used to control the heater/air conditioning blower motor speedTransport CanadaElectricalApr 22, 20158,552 vehicles
- On certain vehicles equipped with a no-idle heating, ventilation and air conditioning (HVAC) module, the electrical harness supplying power to the module may not be of sufficient size, which could cause a voltage drop…Transport CanadaClimateOct 30, 20141,424 vehicles
- Brake s-cam bracket assemblies on the steering axle could fracture, causing an inoperative brake on the affected wheel endTransport CanadaBrakesFeb 20, 201464 vehicles
- A support bracket may contact the fuel tank during frame twist, which could puncture the fuel tank, resulting in fuel leakageTransport CanadaFuel systemNov 26, 2013208 vehicles
- On certain trucks equipped with the electronic fifth wheel jaw release system, incorrect air line routing could allow the fifth wheel jaw to release without driver inputTransport CanadaEquipment › AccessoriesSep 19, 2013185 vehicles
- On certain trucks, the sunshade (an exterior visor mounted above the windshield) may not have been fastened to the cab roof correctly during the manufacturing processTransport CanadaStructureApr 17, 20133,991 vehicles
- On certain trucks, the steer axle S-cam tube bracket assemblies may crack between the wing bracket and the tube steel when mounted to stamped spidersTransport CanadaBrakesNov 21, 20121,156 vehicles
- The tow hooks may not have been correctly heat treated during the manufacturing processTransport CanadaOct 17, 2012133 vehicles
- The steering wheel may have been manufactured incorrectly and could failTransport CanadaSteeringOct 16, 2012924 vehicles
- The piston spring brake chamber may have been manufactured incorrectly and could allow air leakage into the chamberTransport CanadaBrakesSep 19, 201218 vehicles
- On certain trucks, bolts fastening the brake calipers to their mounting plates (on all axles) may not have received adequate tightening torque during vehicle assemblyTransport CanadaBrakesAug 13, 201227 vehicles
- On certain trucks equipped with a MaxxForce 11 or 13 engine, the positive alternator cable may rub against the high pressure power steering hoseTransport CanadaElectricalMay 1, 20122,543 vehicles
- On certain vehicles equipped with Bendix ATR-6 Antilock Traction Relay valves, in extremely cold conditions (at or below -18 degrees Celsius), internal ATR valve leakage can occurTransport CanadaBrakesFeb 10, 20121,741 vehicles