International 5000
Recalls listed for the International 5000, newest first. Pick a year for its full record and owner complaints.
Model years
- Certain vehicle may have been assembled with an incorrectly manufactured Bendix MV-3 dash control valveTransport Canada2009 International 5000BrakesFeb 28, 200897 vehicles
- The hand operated trailer brake control may have a partially blocked delivery port, which can cause the trailer brakes to be slow to apply an release when operated by the hand control valveTransport Canada2003 International 5000BrakesOct 9, 2002367 vehicles
- On certain trucks the fitting that connects the double check valve to the rear axle air brake relay valve may breakTransport Canada2002 International 5000BrakesJun 17, 20025,728 vehicles
- Certain heavy duty trucks equipped with axle assemblies which may have been manufactured with ArvinMeritor 12,000lb, 13,200lb axles, and Dana 9,000 front drive axles built with TRW 20-EDL ball sockets/drags linksTransport Canada2000 International 5000SteeringAug 17, 20012,403 vehicles
- Certain trucks with drag link assemblies built with TRW 24-DL ball socketsTransport Canada2000 International 5000SteeringApr 6, 2001622 vehicles
- The TRW tie rod and drag link ball stud ends contain bearings that are below the specified case depth and/or hardnessTransport Canada2000 International 5000SteeringOct 26, 20001,511 vehicles
- The ABS ECU misinterprets certain signals from wheel ends which can result in the temporary loss of braking capability on one or more wheel positions for several secondsTransport Canada2000 International 5000BrakesSep 28, 200012,886 vehicles
- The Antilock Traction Relay Valves manufactured by Bendix were incorrectly assembledTransport Canada1999 International 5000BrakesFeb 29, 2000201 vehicles
- The knurled pivot shaft (which operates the windshield wiper arm) is welded to a lever, which connects the linkage from the wiper motorTransport Canada1999 International 5000VisibilityMay 19, 1999332 vehicles
- The radius on the cone of the inner wheel bearing was incorrectly machined resulting in improper seating of the cone against the seal flange of the steering knuckleTransport Canada1999 International 5000SuspensionMar 31, 1999666 vehicles
- The automatic slack adjusters may have had insufficient torque applied to the guide pawl cap screwTransport Canada1999 International 5000BrakesMar 31, 1999183 vehicles
- MIS-MATCHED PARTS WERE ASSEMBLED ON SOME SIX SPOKE WHEEL ASSEMBLIES WHICH COULD CAUSE HIGH STRESSES IN THE WHEEL STUDS AND POTENTIAL WHEEL STUD FAILURESTransport Canada1997 International 5000SuspensionAug 13, 1997115 vehicles
- NOTE: VEHICLES EQUIPPED WITH EATON REAR AXLE ASSEMBLIES WITH ANTILOK WHEEL NUTSTransport Canada1997 International 5000SuspensionDec 9, 1996146 vehicles
- DEFECT: THE CASTLE NUTS ON THE BALL STUDS OF THE TIE ROD ENDS MAY NOT BE TIGHTENED TO ROCKWELL'S SPECIFIED TORQUETransport Canada1995 International 5000SteeringJun 21, 199550 vehicles
- NOTE: VEHICLES EQUIPPED WITH WABCO AIR DRYERSTransport Canada1995 International 5000BrakesMar 31, 1995803 vehicles