International 4900
Recalls listed for the International 4900, newest first. Pick a year for its full record and owner complaints.
Model years
- The TRW Model 410M ECU (Electronic Control Unit) can misinterpret particular false wheel speed signals generated from any of the following conditions: An incorrect gap between the sensor and tone ring, a chaffed senso…Transport Canada2003 International 4900BrakesSep 18, 20023,711 vehicles
- On certain trucks the fitting that connects the double check valve to the rear axle air brake relay valve may breakTransport Canada2002 International 4900BrakesJun 17, 20025,728 vehicles
- The s-cam on the front drive axles may experience interference with the knuckle stud as the brake lining wearsTransport Canada1999 International 4900BrakesJan 18, 200018 vehicles
- The rear hydraulic brake hoses that drop from the frame down to the axle for ABS brake systems may be either too long or too shortTransport Canada1999 International 4900BrakesNov 12, 1999550 vehicles
- The radius on the cone of the inner wheel bearing was incorrectly machined resulting in improper seating of the cone against the seal flange of the steering knuckleTransport Canada1999 International 4900SuspensionMar 31, 1999666 vehicles
- The automatic slack adjusters may have had insufficient torque applied to the guide pawl cap screwTransport Canada1999 International 4900BrakesMar 31, 1999183 vehicles
- The tie rod end can pull outboard and separate from the tie rod tube due to improper thread engagement between the male tie rod end and the female tubeTransport Canada1998 International 4900SteeringFeb 22, 19991,052 vehicles
- The transmission flange, parking brake drum and transmission yoke are connected by eight boltsTransport Canada1999 International 4900BrakesSep 29, 1998450 vehicles
- NOTE: VEHICLES EQUIPPED WITH EATON REAR AXLE ASSEMBLIES WITH ANTILOK WHEEL NUTSTransport Canada1997 International 4900SuspensionDec 9, 1996146 vehicles
- DEFECT: THE CASTLE NUTS ON THE BALL STUDS OF THE TIE ROD ENDS MAY NOT BE TIGHTENED TO ROCKWELL'S SPECIFIED TORQUETransport Canada1995 International 4900SteeringJun 21, 199550 vehicles
- THE TURBOCHARGER COMPRESSOR BACKPLATE RETAINING FASTENERS MAY HAVE BEEN IMPROPERLY TORQUEDTransport Canada1995 International 4900EngineAug 8, 1994123 vehicles
- THE PRESSURE REIEF VALVE WAS OMITTED ON THE AIR SUSPENSION RESERVOIR AIR TANKTransport Canada1993 International 4900SuspensionJun 8, 199320 vehicles
- A DEFECTIVE THROTTLE VALVE LOCATED INSIDE THE HYDRAULIC BRAKE BOOSTER, MAY DEFORM FROM A BUILDUP OF HEAT AND PRESSURE AND CLOSE OFF THE HYDRAULIC FLUID RETURN PORTSTransport Canada1990 International 4900BrakesJan 8, 19901,669 vehicles
- THE SCREW WHICH CONNECTS THE RACK TO THE GOVERNOR LINKAGE INSIDE THE BOSCH FUEL INJECTION PUMP MAY HAVE INSUFFICIENT TORQUE ON THE RETAINING NUTTransport Canada1990 International 4900EngineAug 25, 19891,159 vehicles