1995 Gmc Yukon
Safety Recalls & Notices
12 Active Recalls
Requires attention
FUEL SYSTEM, GASOLINE
Summary
CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.
Potential Consequence
THIS CONDITION MAY CAUSE AN INADEQUATE SEAL AT THE CONNECTION, POTENTIALLY LEADING TO A FUEL LEAK. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.
Remedy
HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).
VISIBILITY:WINDSHIELD WIPER/WASHER
Summary
ON CERTAIN MINIVANS, PICKUP TRUCKS, AND SPORT UTILITY VEHICLES WITH CERTAIN MODEL-ENGINE COMBINATIONS, THE WINDSHIELD WIPER MOTOR MAY FAIL DUE TO CRACKED SOLDER JOINTS ON THE CONTROLLER CIRCUIT BOARD. THE WINDSHIELD WIPERS COULD WORK INTERMITTENTLY OR NOT AT ALL.
Potential Consequence
IF THIS WERE TO OCCUR DURING BAD WEATHER, DRIVER VISIBILITY WOULD BE REDUCED, WHICH COULD RESULT IN A CRASH.
Remedy
DEALERS WILL REPLACE THE WIPER MOTOR CIRCUIT BOARD AND COVER. OWNER NOTIFICATION BEGAN ON JUNE 19, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CHEVROLET AT 1-800-222-1020, GMC AT 1-800-462-8782, OR OLDSMOBILE AT 1-800-442-6537.
Other
Summary
Certain vehicles (not involved in recall 98-150), may experience a windshield wiper failure due to cracked solder joints on the controller circuit board. If this were to occur in a severe weather situation, driver's visibility could be reduced, which could result in a vehicle crash without prior warning. Correction: Dealer will replace defective wiper motor until 7 years or 112 000 km from date vehicle was originally placed into service or for those vehicles currently outside of this coverage, until March 31 2004.
Accessories
Summary
On certain vehicles operated in areas of high salt use, the spare tire hoist cable may corrode and eventually break. This would allow the spare tire to fall off the vehicle possibly resulting in a road hazard for other vehicles. Correction: A letter will be sent to owners of affected vehicles with maintenance and inspection instructions for spare tire hoist cable assemblies. Additionally, the letter will advise the owner that, if the cable breaks during that inspection, their dealer will repair the assembly. This policy will be in effect until December 31, 2002.
VISIBILITY:WINDSHIELD WIPER/WASHER
Summary
VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND SPORT UTILITY VEHICLES, 2 AND 4-WHEEL DRIVE. SOLDER JOINTS NEAR THE WIRING HARNESS CONNECTOR CAN CRACK CAUSING THE WINDSHIELD WIPERS TO WORK INTERMITTENTLY.
Potential Consequence
THIS CONDITION CAN RESULT IN INOPERATIVE WIPERS, REDUCING A DRIVER'S VISIBILITY, AND INCREASING THE RISK OF A VEHICLE CRASH.
Remedy
DEALERS WILL REPLACE THE WIPER MOTOR CIRCUIT BOARD AND COVER.
Seats And Restraints
Summary
Certain vehicles exhibit a condition in which a pinch bolt exists in the recliner mechanism that could trap and pinch a person's hand or finger(s) when the easy entry feature is activated. This pinching could cut the hand or possibly sever the finger(s) without prior warning. Correction: a protector will be installed over the recliner mechanism.
Other
Summary
Certain vehicles may not comply with CMVSS 124 - Accelerator Control Systems. Vehicles may have been assembled with the throttle cable contacting the dash mat. The dash mat may bind the throttle cable such that the throttle return time may not meet the requirements of the standard. Correction: Dealers will inspect for adequate throttle cable to dash mat clearance, and if there is insufficient clearance, a portion of the dash mat will be cut out to provide clearance.
VEHICLE SPEED CONTROL
Summary
THESE VEHICLES WERE ASSEMBLED WITH THE THROTTLE CABLE CONTACTING THE DASH MAT WHICH COULD BIND THE THROTTLE. THIS DOES NOT MEET WITH THE MAXIMUM RETURN TIMES REQUIRED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, "ACCELERATOR CONTROL SYSTEMS."
Potential Consequence
CONSEQUENCE OF NON-COMPLIANCE: THE ENGINE SPEED MAY NOT RETURN TO IDLE INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.
Remedy
DEALERS WILL INSPECT FOR ADEQUATE THROTTLE CABLE TO DASH MAT CLEARANCE, AND IF THERE IS INSUFFICIENT CLEARANCE, CUT OUT A PORTION OF THE DASH MAT TO PROVIDE PROPER CLEARANCE.
POWER TRAIN:AUTOMATIC TRANSMISSION
Summary
THE TRANSMISSION SHIFT-CABLE LOCK CLIP CAN BACK OUT OF ITS INSTALLED POSITION RESULTING IN A LOSS OF CABLE ADJUSTMENT. WHEN THE SHIFT LEVER IS PLACED IN THE "PARK" POSITION, THE "PARK" INDICATOR LIGHT MAY NOT ILLUMINATE.
Potential Consequence
THE VEHICLE CAN MOVE UNINTENTIONALLY IF THE DRIVER DOES NOT NOTICE THAT THE INDICATOR LIGHT IS NOT ON AND DOES NOT APPLY THE PARKING BRAKE.
Remedy
DEALERS WILL ADJUST THE SHIFT CABLE AND INSTALL A LOCK CLIP.
AIR BAGS
Summary
THE VEHICLES HAVE BOTH THE SUPPLEMENTAL INFLATABLE RESTRAINT (SIR) LABEL AND AN ENGINE START LABEL INSTALLED ON THE SAME SIDE OF THE SUN VISOR. THIS DOES NOT COMPLY WITH FMVSS NO.208, "OCCUPANT CRASH PROTECTION."
Potential Consequence
CONSEQUENCE OF NON-COMPLIANCE: OPERATORS COULD FAIL TO NOTICE AND HEED THE WARNING LABEL.
Remedy
THE ENGINE START LABEL WILL BE REMOVED FROM THE STOWED SIDE OF THE SUN VISOR AND A NEW ENGINE START LABEL WILL BE INSTALLED ON THE HEADLINER IN THE SUN VISOR DEPRESSION. OWNERS WILL RECEIVE THE NEW LABEL AND CAN INSTALL THE LABEL THEMSELVES OR HAVE A DEALER INSTALL IT.
SEAT BELTS:REAR/OTHER
Summary
VEHICLES FAIL TO CONFORM TO FMVSS NO. 210, "SEAT BELT ANCHORAGES." THE CENTER REAR SEAT LAP BELT WAS IMPROPERLY ROUTED.
Potential Consequence
CONSEQUENCE OF NON-COMPLIANCE: THE OCCUPANT OF THIS SEAT WILL NOT BE PROPERLY RESTRAINED IN THE EVENT OF A VEHICLE CRASH.
Remedy
INSTRUCTIONS FOR REROUTING THE CENTER REAR SEAT LAP BELT WILL BE SENT TO THE VEHICLE OWNERS. IF THE OWNER PREFERS, THEY CAN TAKE THEIR VEHICLE TO THEIR DEALER AND HAVE IT REROUTED FREE OF CHARGE BY THE DEALER.
Seats And Restraints
Summary
THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 210 - SEAT BELT ASSEMBLY ANCHORAGES. THE REAR SEAT CENTRE LAP BELT MAY HAVE BEEN ROUTED OVER THE SEAT FRAME RATHER THAN UP THROUGH THE HOLE IN THE LOWER CUSHION. CORRECTION: CENTRE LAP BELT WILL BE CORRECTLY ROUTED.
Generated by Cardog • December 16, 2025
1995 Gmc Yukon
Safety Recalls & Notices
12 Active Recalls
Requires attention
