2006 Freightliner Coronado
Transport Canada lists 14 recalls for the 2006 Freightliner Coronado.
Confirm with a Freightliner dealer · Only the manufacturer confirms which recalls apply to one VIN.
14 recalls
- On certain trucks equipped with "Fleet Engineer" mud flaps, the bracket for the mud flaps may partially cover the rear reflective tapeTransport CanadaLightingApr 14, 2020873 vehicles
- On certain trucks equipped with a Detroit Diesel DD13, DD15 or DD16 engine, the support system for the high pressure fuel line (between the fuel pump and the fuel delivery rail) may be damaged during a service repair…Transport CanadaFuel systemFeb 27, 201211,923 vehicles
- Specific operating conditions (such as tight, successive, highly banked curves in opposite directions), could trigger unintended Electronic Stability Control (ESC) system interventionTransport CanadaSep 19, 20111,027 vehicles
- On certain vehicles equipped with a Caterpillar C15 engine, the Variable Valve Actuation (VVA) oil line may wear against the P-clip retaining the oil lineTransport CanadaEngineSep 22, 20095,647 vehicles
- On certain trucks, the high-pressure fuel line at each injector may fatigue and fracture if a fastener at the end of the line is not properly connectedTransport CanadaFuel systemMar 4, 20085,007 vehicles
- On certain trucks, the fifth wheel hitch assembly's lever arm may have been incorrectly installed during the manufacturing processTransport CanadaNov 7, 20071,063 vehicles
- On certain trucks, the wiper motor ground wire was omitted during vehicle assemblyTransport CanadaElectricalNov 7, 2007387 vehicles
- On certain trucks, the driver's side inner tie rod may be damaged while the truck is executing a sharp turnTransport CanadaSteeringAug 29, 200710 vehicles
- The internal rubber check valve inside the Bendix SR-7 spring brake modulating valve can become deformed over timeTransport CanadaBrakesJul 11, 200718,536 vehicles
- The steering column may have been manufactured incorrectlyTransport CanadaSteeringJun 26, 20071,544 vehicles
- The protective cover for the cab Power Distribution Module (PDM) may be missing or improperly installedTransport CanadaElectricalJun 5, 20062,927 vehicles
- The steering wheel was manufactured with incorrect length Huck fasteners that are too short to allow proper retaining collar engagementTransport CanadaSteeringJan 12, 2006361 vehicles
- A manufacturing defect of the front axle I-beam top flange may result in a reduction of axle service lifeTransport CanadaSuspensionDec 2, 200550 vehicles
- The rear spindles may fracture as a result of incorrect heat treat process during vehicle assemblyTransport CanadaSuspensionOct 18, 200580 vehicles