1997 Chevrolet Monte Carlo
Safety Recalls & Notices
We found 5 safety recalls for the 1997 Chevrolet Monte Carlo. Recalls are sourced from both NHTSA (US) and Transport Canada databases. Contact your authorized Chevrolet dealer to schedule free repairs.
Summary
On certain vehicles, the lower pinion bearings retainer tabs were not crimped properly. These retainers may fail and permit the ball bearings to escape. If the problem were to occur, the driver would have to exert more effort to turn the steering wheel. Correction: Dealers are to inspect the condition of the lower bearing, and replace the lower pinion bearing or the rack and pinion steering gear assembly, if necessary. This is an extension of recall 02-199
Summary
On certain vehicles, the spark plug wires may be causing the Malfunction Indicator Lamp (MIL) to be illuminated, as well as causing rough idle and poor performance. These conditions may be due to a dielectric breakdown of the plastic extender piece at the boot joint of the spark plug wire. Correction: Dealers will replace all six spark plug wires with a new service spark plug wire assembly kit that is designed to be robust against dielectric breakdown failures.
Summary
CERTAIN DELPHI FUEL PRESSURE REGULATORS, P/NOS. FP10020-11B1, FP10026-11B1, AND FP10027-11B1, SOLD AFTER JANUARY 9, 2007, AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE UNIVERSAL PRESSURE REGULATORS (UPR) WERE PRODUCED WITHOUT AN O'RING AND RETAINER.
Potential Consequence
FUEL MAY LEAK, POSSIBLY RESULTING IN A FIRE.
Remedy
DELPHI WILL NOTIFY OWNERS AND REPLACE THE UPR FREE OF CHARGE. THE RECALL BEGAN ON APRIL 23, 2007. OWNERS CAN CONTACT DELPHI AT 877-411-8770.
Summary
CERTAIN PASSENGER VEHICLES HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE RETAINERS COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE.
Potential Consequence
IF THIS OCCURS, THE PINION SHAFT CAN BE FORCED UPWARD DURING LEFT TURNS AND BACK DOWN AS THE STEERING WHEEL IS MOVED BACK AND TO THE RIGHT. IF THE PINION SHAFT MOVES FURTHER, THE DRIVER WILL NEED TO EXERT MORE EFFORT TO TURN THE STEERING WHEEL, SIMILAR TO A VEHICLE WITHOUT POWER ASSISTED STEERING. IF THE PINION SHAFT MOVES EVEN FURTHER, THE DRIVER WILL REQUIRE MUCH HIGHER EFFORT TO TURN LEFT AND MAY NOT BE ABLE TO TURN THE WHEEL AS MUCH AS INTENDED. WITH THE MAXIMUM PINION SHAFT MOVEMENT, WHICH REQUIRES INTERNAL GEAR COMPONENT DAMAGE, THE DRIVER CAN ENCOUNTER HIGH RESISTANCE TO TURNING LEFT, FOLLOWED BY UNINTENDED POWER ASSIST TO THE RIGHT. IN ANY OF THESE CONDITIONS, A CRASH COULD OCCUR.
Remedy
DEALERS WILL INSTALL A NEW LOWER PINION BEARING UNLESS INSPECT OF THE EXISTING BEARING INDICATES THAT REPLACEMENT OF THE GEAR ASSEMBLY IS NECESSARY. OWNER NOTIFICATION BEGAN ON FEBRUARY 5, 2004. OWNERS SHOULD CONTACT BUICK AT 1-866-608-8080; CHEVROLET AT 1-800-630-2438; OLDSMOBILE AT 1-800-630-6537; OR PONTIAC AT 1-800-620-7668.
Summary
THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: 1995-1999 CHEVROLET MONTE CARLO Z34 PASSENGER VEHICLES. THE BRAKING PERFORMANCE IN WET WEATHER OR WET ROAD CONDITIONS IS REDUCED MORE THAN A DRIVER WOULD EXPECT.
Potential Consequence
THE BRAKING COULD FEEL DELAYED MOMENTARILY WHEN LIGHT OR MODERATE FORCE IS APPLIED ON THE BRAKE PEDAL WHILE DRIVING ON WET ROADS OR AFTER GOING THROUGH A CAR WASH.
Remedy
DEALER WILL MODIFY THE FRONT FENDER LINERS TO REMOVE A PORTION OF THE CLOSEOUT PANELS IN THE FRONT WHEEL WELLS AT NO CHARGE TO THE CONSUMER. THIS SERVICE WILL BE AVAILABLE THROUGH AUGUST 2004.
5 Active Recalls
Requires attention
1997 Chevrolet Monte Carlo Recall FAQs
Common questions about recalls for this vehicle
Related Recall Checks
Browse recall information for the latest model year vehicles.