Safety Recalls & Notices
Requires attention
Issue: This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones. Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act. Safety Risk: Glass that breaks in to large pieces could create a risk of injury. Corrective Actions: The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.
On certain vehicles, a defect in the ignition switch could allow the switch to move out of the "run" position if the key ring is carrying added weight or the vehicle goes off-road or is subjected to some other jarring event. If this were to occur, engine power, power steering and power braking would be affected, increasing the risk of a crash causing injury and/or damage to property. The timing of the key movement out of the “run” position, relative to the activation of the sensing algorithm of the crash event, may also result in the airbags not deploying in a subsequent collision, increasing the risk of injury. Correction: For each key, dealers will install two key rings and modify the key ring opening shape. Note: Until the correction is performed, all items should be removed from the key ring.
This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring. General Motors LLC (GM) is recalling certain model year 2005-2009 Buick LaCrosse, 2006-2011 Buick Lucerne, 2000-2005 Cadillac DeVille, 2006-2011 Cadillac DTS, 2006-2014 Chevrolet Impala, and 2006-2007 Chevrolet Monte Carlo vehicles. In the affected vehicles, the weight on the key ring and road conditions or some other jarring event may cause the ignition switch to move out of the run position, turning off the engine.
If the key is not in the run position, the air bags may not deploy if the vehicle is involved in a crash, increasing the risk of injury. Additionally, a key knocked out of the run position will cause loss of engine power, power steering, and power braking, increasing the risk of a vehicle crash.
GM will notify owners, and dealers will install two key rings and an insert in the key slot or a cover over the key head on all ignition keys, free of charge. The recall began on September 23, 2014. Owners may contact General Motors customer service at 1-800-521-7300 (Buick), 1-800-458-8006 (Cadillac), and 1-800-222-1020 (Chevrolet). GM's number for this recall is 14299.
On certain Chevrolet Impala police vehicles, the front control arms may fracture. If this occurs, some tire "squeal" or "chirping" may be heard when turning at low speeds. Sudden changes could occur in vehicle handling and, particularly at higher speeds, the driver may not be able to control the vehicle and a crash could occur, which may result in personal injury and/or property damage. Correction: Dealers will replace both control arms.
General Motors (GM) is recalling certain model year 2008-2012 Chevrolet Impala police vehicles because the front lower control arms may fracture. This safety recall does not include non-police Chevrolet Impala vehicles.
A broken control arm can result in the loss of control of the vehicle, increasing the risk of a crash.
GM will notify owners, and dealers will replace both front lower control arms, free of charge. The safety recall began on August 21, 2012. Owners may contact the Chevrolet owner center at 1-866-694-6546.
On certain vehicles equipped with a 3.6L engine, the high pressure (upper) power steering hose may have been misrouted and could contact the catalytic converter. With the engine ON, heat from the catalictic converter may melt the power steering hose. If this occurs, power steering fluid could flow onto the catalytic converter, which could result in a fire causing property damage and/or personal injury. Correction: Dealers will ensure that the upper power steering hose is routed correctly. If it is not, the upper power steering hose will be replaced. Dealers will also install a protective sleeve around both power steering hoses, on all vehicles (regardless of routing), to prevent abrasion of the power steering hoses.
GM IS RECALLING CERTAIN MODEL YEAR 2012 CHEVROLET IMPALA VEHICLES MANUFACTURED FROM APRIL 19, 2011, THROUGH JULY 29, 2011. THE UPPER POWER STEERING HOSE MAY HAVE BEEN MISROUTED SO THAT IT CAN COME IN CLOSE PROXIMITY TO AND/OR CONTACT THE CATALYTIC CONVERTER. WITH THE ENGINE ON, HEAT FROM THE CATALYTIC CONVERTER MAY MELT THE POWER STEERING HOSE.
POWER STEERING FLUID COULD FLOW ONTO THE CATALYTIC CONVERTER, AND AN ENGINE COMPARTMENT FIRE COULD OCCUR.
GM DEALERS WILL INSPECT TO ENSURE THAT THE UPPER POWER STEERING HOSE IS ROUTED CORRECTLY AND MAKE THE NECESSARY REPAIRS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON SEPTEMBER 5, 2011. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438.
Generated by Cardog • December 11, 2025
Safety Recalls & Notices
Requires attention