Safety Recalls & Notices
Requires attention
BMW of North America, LLC (BMW) is recalling certain 2008-2013 1 Series Coupe (128i); 2007-2013 3 Series Coupe (328i, 328xi, 328i xDrive); 2007-2010 X3 SAV (X3 3.0si, X3 xDrive30i); 2008-2013 1 Series Convertible (128i); 2006-2011 3 Series Sedan (325i, 325xi, 328i, 328xi, 328i xDrive, 330i, 330xi); 2006-2012 3 Series Wagon (328i, 328i xDrive); 2007-2013 3 Series Convertible (328i); 2006-2010 5 Series Sedan (525i, 525xi, 528i, 528xi, 530i, 530xi); 2006-2007 5 Series Wagon (530xi); 2007-2010 X5 SAV (X5 3.0si, X5 xDrive30i); 2006-2008 Z4 Coupe (Z4 3.0si); and 2006-2011 Z4 Roadster (Z4 3.0i, Z4 3.0si, Z4 sDrive30i) vehicles. The heater for the positive crankcase ventilation (PCV) valve may short circuit.
An electrical short can cause the PCV valve heater to overheat, increasing the risk of a fire while driving or, soon after driving when parked.
This recall supersedes and expands previous NHTSA recalls 17V-683 and 19V-273. Dealers will install an electrical wiring harness with fuse protection for the PCV Valve heater in potentially affected vehicles, free of charge. This recall supersedes and expands previous NHTSA recalls 17V-683 and 19V-273. Vehicles previously repaired under the prior recalls will need to come back for the new recall remedy. The remedy is currently being developed. Interim owner notification letters informing owners of the safety risk were mailed on April 1, 2022. Owner notification letters were mailed on July 22, 2022. Owners may contact BMW customer service at 1-800-525-7417.
Issue: On certain vehicles equipped with an N52 or N52K 6-cylinder engine, a manufacturing problem could cause the PCV valve heater (blow-by heater) to short circuit and overheat. Note: This replaces Transport Canada recalls 2017-470 and 2019-170. Only vehicles equipped with an N52 or N52K engine require this repair. Safety Risk: An overheated engine PCV valve heater could create the risk of a fire, even while the vehicle is parked and turned off. Corrective Actions: BMW will notify owners by mail and instruct you to take your vehicle to a dealer to install a wire harness repair kit. BMW recommends that you should park your vehicle outdoors until the recall repairs have been completed.
Issue: On certain vehicles equipped with an N52 6-cylinder engine, a manufacturing problem could cause the PCV valve heater to overheat. Safety Risk: An overheated engine PCV valve heater could create the risk of a fire. Corrective Actions: The company will notify owners by mail and instruct you to take your vehicle to a dealer to replace the PCV valve heater.
On certain vehicles, the front passenger seat occupant detection mat can fatigue over time. As a result, the passenger airbag could deactivate, illuminating the airbag warning lamp and the passenger airbag ON/OFF lamp. Failure of the passenger airbag to deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Correction: Vehicles will receive special extended warranty coverage of 10 years from first registration. Under this special coverage program, vehicles which experience this condition will have the occupant detection mat replaced.
This recall involves aftermarket parts sold by Valeo. Valeo is recalling certain engine cooling fans, part numbers 696121, 696273, and 696275, used as service replacement parts for model year 2008-2011 BMW 1-Series, 2006-2011 BMW 3-Series, 2000-2009 BMW 5-Series, 2004-2005 BMW 6-Series, and 2006-2007 BMW 7-Series vehicles. A metal-oxide semiconductor may overheat due to insufficient screwing of the semiconductor on the aluminum heat sink. This primary failure could cause adjacent components on the fan assembly motor circuit board to overheat and short.
This condition could cause the fan motor to become inoperative, or cause the motor circuit board in the assembly to overheat, potentially leading to a fire in the engine compartment.
Valeo will notify owners and replace the fans free of charge. The safety recall began on August 22, 2012. This recall is being conducted by Valeo, not by BMW. For further information, owners may contact Valeo at 1-888-718-2536.
BMW IS RECALLING CERTAIN MODEL YEAR 2004-2010 5-SERIES, MODEL YEAR 2004-2010 6-SERIES, MODEL YEAR 2006-2010 M5, AND MODEL YEAR 2007-2010 M6 VEHICLES. THE INSULATED BULKHEAD CONNECTOR FOR THE POSITIVE BATTERY CABLE MAY HAVE BEEN INCORRECTLY ATTACHED TO THE TRUNK FLOOR PANEL, WHICH CAN LEAD TO A LOOSENING OF THE BOLT CONNECTION. AS IT LOOSENS, AN INCREASE IN ELECTRICAL RESISTANCE AT THIS CABLE CONNECTION IS POSSIBLE AND COULD CAUSE THE CABLE CONNECTION TO OVERHEAT.
OVERHEATING COULD LEAD TO A FIRE, EVEN WHILE THE VEHICLE IS NOT IN USE. AS A PRECAUTION, OWNERS ARE ADVISED TO PARK OUTSIDE UNTIL THE REMEDY HAS BEEN MADE.
BMW WILL NOTIFY OWNERS, AND DEALERS WILL INSPECT AND SECURE THE BATTERY BOLT CABLE CONNECTION AS NECESSARY, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON APRIL 30, 2012. OWNERS MAY CONTACT BMW CUSTOMER RELATIONS AND SERVICES AT 1-800-525-7417.
On certain vehicles, the insulated bulkhead connector (used to join the two halves of the positive battery cable) may have been incorrectly installed during vehicle assembly. Over time, the bolt connection could loosen, which would increase electrical resistance. In addition, an incorrectly insulated bulkhead connector could allow humidity to accumulate at this location, causing current leakage. These issues could cause the cable connection to overheat, which could result in a vehicle fire causing property damage and/or personal injury. Correction: Dealers will inspect and, as necessary, secure the insulated bulkhead connector. In addition, protective grease will be added to the area and the plastic battery positive terminal cover will be replaced.
On certain vehicles, a check valve in the brake vacuum pump may leak a small amount of lubricating oil. Over time, this could result in contamination of the brake booster. Loss of brake power assist could occur which, in conjunction with traffic, road conditions, and driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the brake booster and master cylinder. Additionally, the brake vacuum line (including the check valve) will be replaced to eliminate the possibility of oil reaching the brake booster.
BMW IS RECALLING CERTAIN MODEL YEAR 2004-2010 5-SERIES, 6-SERIES, AND MODEL YEAR 2002-2008 7-SERIES VEHICLES. A CHECK VALVE OF THE BRAKE VACUUM PUMP MAY LEAK A SMALL AMOUNT OF LUBRICATING OIL. OVER TIME THIS COULD RESULT IN CONTAMINATION OF THE BRAKE BOOSTER.
POWER ASSIST BRAKING PERFORMANCE COULD BE ADVERSELY AFFECTED. IN EXTREME CASES THERE COULD BE A COMPLETE LOSS OF POWER ASSIST BRAKING. AN UNEXPECTED REDUCTION OR LOSS IN POWER BRAKING ASSIST MAY INCREASE THE RISK OF A CRASH.
BMW WILL NOTIFY OWNERS AND DEALERS WILL REPAIR THE VEHICLES FREE OF CHARGE. THE SAFETY RECALL BEGAN ON NOVEMBER 24, 2010. OWNERS MAY CONTACT BMW AT 1-800-525-7417.
On certain vehicles, the front passenger seat occupant detection mat can fatigue during field usage depending on the seat configuration, vehicle geometry, manner and frequency of front passenger entry/exit. Over time micro cracks could develop in the side flanks of the mat, which could lead to a break of the conductive path and the system will recognize a failure and with exception of head protection system the front passenger air bag will be deactivated. The airbag On/Off lamp will be illuminated to make the occupants aware of the deactivation. Correction: The occupant detection mat will be granted a warranty extension of 10 years.
BMW IS RECALLING 200,000 MY 2006 3 SERIES SPORT SEAT, MY 2004-2006 5 SERIES STANDARD AND SPORT SEAT, AND MY 2004-2006 X3 PASSENGER VEHICLES. DEPENDING ON THE MANNER AND FREQUENCY OF THE FRONT PASSENGER'S ENTRY AND EXIT, SMALL CRACKS HAVE DEVELOPED IN THE MAT. IF THIS OCCURS, THE FRONT PASSENGER AIR BAGS, WITH THE EXCEPTION OF THE HEAD PROTECTION SYSTEM, WILL BE DEACTIVATED AND THE AIR BAG WARNING LAMP AS WELL AS THE PASSENGER AIR BAG "ON-OFF" LAMP WILL BE ILLUMINATED.
IN THIS SITUATION THE FRONT PASSENGER AIR BAGS WILL NOT DEPLOY EVEN IF A SUFFICIENTLY SEVERE ACCIDENT WOULD OCCUR AND OCCUPANT PROTECTION PROVIDED BY THE SYSTEM WOULD NOT BE POSSIBLE.
DEALERS WILL REWORK THE FRONT PASSENGER SEAT SENSOR MAT SO THAT EXTERNAL FORCE APPLICATION TO THE SEAT DOES NOT CAUSE A CRACK TO THE MAT. THE RECALL BEGAN ON NOVEMBER 6, 2008. BMW WILL ALSO EXTEND THE WARRANTY ON THESE VEHICLES TO 10 YEARS FROM FIRST REGISTRATION WITHOUT ANY MILEAGE LIMIT. OWNERS MAY CONTACT BMW AT 1-800-525-7417.
Certain 550I, 650I cabriolet, 650I coupe, and X5 vehicles equipped with a V8 engine, operated in conditions of below-freezing temperatures combined with low humidity, may suffer an electrostatic discharge at the fuel rails. If this were to occur, the engine's Electronic Control Unit (ECU) could be affected such that engine stalling could result. If the engine were to stall, this would result in a loss of power steering. Loss of power steering could lead to a condition in which vehicle handling and control were impaired. Correction: Dealers will install two additional ground cable between the fuel rails and the ground connection of the ignition coils.
ON CERTAIN PASSENGER VEHICLES, THE LOWER RUBBER MOUNT OF THE REAR SHOCK ABSORBERS MAY NOT HAVE BEEN MANUFACTURED TO SPECIFICATIONS AND MAY NOT ADHERE CORRECTLY TO ITS HOUSING WITHIN THE SHOCK ABSORBER.
THE BUSHING COULD LOOSEN AND OVER TIME COULD SEPARATE FROM ITS HOUSING. THE DRIVER WILL EXPERIENCE IMPAIRED VEHICLE HANDLING AND CONTROL INCREASING THE RISK OF A CRASH.
DEALERS WILL REPLACE THE REAR SHOCK ABSORBER FREE OF CHARGE. THE RECALL BEGAN ON SEPTEMBER 13, 2006. OWNERS MAY CONTACT BMW AT 1-800-831-1117.
On certain vehicles, the rear shock lower bushings may not have been manufactured to specification (improper vulcanization of the bushing). Depending on vehicle operation and temperature conditions, this could lead to a loosening of the bushing within its housing. Over time, the bushing could continue to loosen and may eventually separate from its housing. Correction: Dealers will replace the rear strut assemblies.
ON CERTAIN PASSENGER VEHICLES, THE NUTS WHICH SECURE THE FRONT AXLE CONTROL ARM AND TENSION STRUT TO THE FRONT WHEEL HUB MAY NOT HAVE BEEN TIGHTENED TO SPECIFICATION. OVER TIME THE NUTS COULD LOOSEN AND THE CONTROL ARM AND TENSION STRUT COULD BE DAMAGED.
VEHICLE HANDLING AND CONTROL COULD COMPROMISE INCREASING THE RISK OF A CRASH.
DEALERS WILL RETIGHTEN THE FRONT AXLE CONTROL ARM AND TENSION STRUT NUTS TO THE CORRECT SPECIFICATIONS FREE OF CHARGE. THE RECALL BEGAN ON JUNE 28, 2006. OWNERS MAY CONTACT BMW AT 1-800-831-1117.
CERTAIN PASSENGER VEHICLES MAY HAVE BEEN BUILT WITH AN INCORRECTLY MANUFACTURED AUTOMATIC TRANSMISSION PARKING PAWL GUIDE PLATE.
THIS COULD CAUSE THE PARKING LOCK SYSTEM NOT TO ENGAGE, AFTER THE TRANSMISSION IS PLACED IN THE PARK ("P") POSITION. IF THE VEHICLE WAS PARKED ON AN INCLINE, AND THE PARKING BRAKE WAS NOT ENGAGED, THIS COULD RESULT IN A VEHICLE ROLLAWAY CONDITION.
DEALERS WILL REPAIR AND REPLACE THE AUTOMATIC TRANSMISSION GUIDE PLATE FREE OF CHARGE. THE RECALL BEGAN ON NOVEMBER 30, 2005. OWNERS MAY CONTACT BMW AT 1-800-332-4269.
On certain vehicles, the guide plate of the automatic transmission's parking lock pawl subsystem may fail. This could cause the parking lock pawl not to engage, after placing the transmission in the PARK position. If the vehicle was parked on an incline of sufficient grade, and the parking brake was not engaged, the vehicle could roll away. Correction: Dealers will replace the guide plate.
Generated by Cardog • December 15, 2025
Safety Recalls & Notices
Requires attention