National Highway Traffic Safety Administration2016 Tesla Model XSteering
In early Mid-September 2026 the vehicle developed a sudden grinding/rubbing noise while turning, with difficulty turning
ODI Happened September 15, 2026Filed November 10, 2026
In the owner's words
In early Mid-September 2026 the vehicle developed a sudden grinding/rubbing noise while turning, with difficulty turning. No prior warning lights or alerts occurred. A Tesla Service Center diagnosed a failed steering rack. Upon disassembly, the aluminum housing showed heavy corrosion and pitting with housing in areas corroded away, especially around the intermediate shaft (I-shaft) area and fastener interfaces. Multiple steel bolts and nuts were heavily rusted. After removing the lower cover below the I-shaft pinion gear, the cavity containing the retaining nut was found completely full of water, confirming prolonged moisture intrusion into the rack housing near the pinion and torque-sensor components. This failure matches the moisture-ingress corrosion mode addressed by NHTSA recall 20V-062 (Tesla SB-20-32-002), which covered Model X vehicles built through October 18, 2016 due to corrosion of Bosch aluminum bolts and water intrusion that could cause loss of power assist or binding. This vehicle was built only about two weeks after the official cutoff yet exhibits the identical failure mechanism, including standing water inside the pinion cavity. Corrosion and water intrusion in the steering rack can cause sudden binding, increased steering effort, or loss of power assist, reducing the driver’s ability to control the vehicle at low speeds or in an emergency. The same hazard NHTSA previously determined warranted a recall is present on this post-cutoff vehicle. Photographs of the corroded housing, rusted fasteners, and water-filled cavity are attached. Video of the Rack Teardown available upon request (extremely large file size) Tesla diagnostic notes and the repair estimate are available on request. I request NHTSA review this post-cutoff failure in the context of recall 20V-062 and evaluate whether the October 18, 2016 production cutoff adequately addressed the corrosion risk. Vehicle used on-road only, no off-road use. Vehicle never driven through high water.
An owner's report to NHTSA. NHTSA reads every complaint to decide what to investigate; it doesn't verify them, and a complaint is not a recall.