National Highway Traffic Safety Administration2026 GMC YukonEngine

So the ultimate failure is from a catastrophically failed crankshaft journal thrust bearing

ODI Happened June 1, 2026Filed June 1, 2026

In the owner's words

So the ultimate failure is from a catastrophically failed crankshaft journal thrust bearing. Which could be caused from one of two things: 1) The crankshaft thrust bearings they are putting in these motors are made with inferior materials, probably cheap Chinese crap or 2) The crankshaft end play tolerance was never set properly, giving the crankshaft the ability to move forward and backward in the engine more than it was designed to. Which will over time beat up on the thrust bearing until it fails. In either case it would result in the same progressive issue showing itself. It will start as a squeak here and there. Which, as the soft thrust bearing material is unable to hold the proper oil film thickness for lubrication, will spiral into more and more heat being sent into the adjacent components, plus the buildup of metal particles being sent through the entire engine oiling system. Which will then start killing connecting rod and crankshaft bearings one by one. If the engine survived to this point, it’s now a ticking time bomb. It is either going to just seize up and not run anymore or the exciting route would be a connecting rod breaks and makes a window sized hole in the side of the engine block.

An owner's report to NHTSA. NHTSA reads every complaint to decide what to investigate; it doesn't verify them, and a complaint is not a recall.