National Highway Traffic Safety Administration2016 Tesla Model SElectrical

I am writing to formally report a recall-related safety defect that occurred after the eMMC recall service on my vehicle’s Media Control Unit (MCU)

ODI Happened November 7, 2025Filed November 9, 2025

In the owner's words

I am writing to formally report a recall-related safety defect that occurred after the eMMC recall service on my vehicle’s Media Control Unit (MCU). Following the recall, the display adhesive began to leak and the screen started separating from its frame. The adhesive continues to drip onto the dashboard and the display shows signs of delamination. This is a safety issue that directly affects driver visibility and may result in electrical contamination inside the MCU. Under federal law, Tesla is required to correct any defect that is related to or arises from a recalled component. This obligation is clearly stated in 49 U.S. Code Section 30120 and 49 CFR Section 573.6. The adhesive leakage and display delamination meet the definition of a related safety defect under 49 CFR Section 573.5(c) because the problem is connected to the same system that was recalled and repaired. A manufacturer performing a recall repair must return the system to safe operating condition. Tesla is therefore responsible for verifying and correcting any new or worsening safety defect identified during or after recall service. Tesla’s own internal Service Bulletin SB-21-17-003 confirms this obligation. It states that if display delamination, bubbling, or adhesive leakage is observed, the entire MCU assembly must be replaced. The service department’s statement that Tesla is “not obligated” to inspect or replace the screen is incorrect and contradicts both federal recall requirements and Tesla’s own technical documentation.

An owner's report to NHTSA. NHTSA reads every complaint to decide what to investigate; it doesn't verify them, and a complaint is not a recall.