National Highway Traffic Safety Administration2009 Chevrolet CorvetteEngine, Brakes, Steering
Engine had excessive noise
ODI Happened January 23, 2015Filed January 25, 2015
In the owner's words
Engine had excessive noise. After reading several corvette complaints about improperly machined heads by general motor's supplier linamar, and that numerous vehicles have had valves drop and catastrophic engine failure, I had my car with checked at a specialty shop. I had several valve guides outside of service specifications. The car is being repaired with proper re-machining of the heads to make the valve guides concentric, new intake and exhaust valve guides installed, as well as new seals, valves, springs, etc. 88% of the corvette forum members who have had their cylinder heads tested for excessive valve guide wear, were out of service specifications. Source: http://www.corvetteforum.com/forums/...-registry.html gm needs to issue a recall on this issue. There have been numerous engine failures as a result of a dropped valve into a cylinder. This stops the engine, power steering, and power brakes which can cause accidents and fires. Gm is very aware of this issue, but refuses to do anything about this huge safety risk to drivers, passengers, and nearby vehicles if the engine fails going down the road. Regards. *tr
An owner's report to NHTSA. NHTSA reads every complaint to decide what to investigate; it doesn't verify them, and a complaint is not a recall.