National Highway Traffic Safety Administration2002 Toyota CorollaOccupant protection › Seats
About a week ago, driver seat could not return to upright position after adjusting angle
ODI Happened January 1, 2012Filed January 9, 2012
In the owner's words
About a week ago, driver seat could not return to upright position after adjusting angle. Then we noticed large piece of seat back frame was protruding on the left-hand side. Upon removal of covering and cushion to uncover the back frame, we discovered that, of the two solid-steel arms attaching the back frame to the bottom part of the bucket seat (the adjuster mechanism), the arm on the left-hand side has been split into two separate pieces, along a horizontal break in the steel itself. In short, the left half of the seat back frame is not attached anymore. Initially we suspected vandalism, but the break is definitely not a saw cut (even if were possible); and we also discovered that the steel arm on the right-hand side has a half-inch long crack in almost exactly the same spot, and also horizontal. This led us to conclude that the break on the left arm was due to a developing crack in the steel, and the right arm is clearly headed towards an identical fracture -- which would completely separate the seat back frame from the bucket seat altogether! The two steel arms are clearly made of sub-standard material. Without considering the significant cost of replacing the bucket seat, this is clearly a serious safety hazard, since at any moment the seat back could collapse completely due to sub-standard steel parts tearing apart. It is fortunate this was discovered while the vehicle was not in motion. This is definitely a safety recall issue. We have several photos of these defects, including close-ups, ready to send you upon request. *tr
An owner's report to NHTSA. NHTSA reads every complaint to decide what to investigate; it doesn't verify them, and a complaint is not a recall.