2007 Ford Crown Victoria
Safety Recalls & Notices
7 Active Recalls
Requires attention
Steering
Summary
Certain vehicles serviced as part of recall 2013-287 (13S08) or special service campaign 13R01 may require re-inspection and repair. The service procedure may have resulted in over-extension of one part of a collapsible joint in the intermediate steering shaft. This could potentially result in the shaft becoming disconnected, resulting a loss of steering, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the intermediate shaft connection and replace the intermediate shaft if necessary.
STEERING:RACK AND PINION:PINION SHAFT
Summary
Ford Motor Company (Ford) is recalling certain model year 2005-2011 Ford Crown Victoria, 2005-2011 Mercury Grand Marquis vehicles manufactured March 23, 2004, to August 30, 2011, and 2005-2011 Lincoln Town Car vehicles manufactured March 8, 2004, to August 30, 2011, and on which the upper intermediate shaft was serviced during the course of safety recall 13V-385. The prior repairs may not have been correctly performed.
Potential Consequence
Improper servicing of the upper intermediate shaft could cause the shaft to separate, which can then result in a loss of steering control, and increasing the risk of a crash.
Remedy
Ford will notify the owners of vehicles whose repair records reflect that the upper intermediate steering shaft was repaired during the course of the prior recall 13V-385. Dealers will inspect and replace the upper immediate shaft if necessary free of charge. The recall began November 17, 2014. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 14S25.
STEERING
Summary
Ford is recalling certain model year 2005-2011 Ford Crown Victoria (including Crown Victoria Police Interceptors), Mercury Grand Marquis, and Lincoln Town Car vehicles. The affected vehicles are currently registered or were originally sold in Connecticut, Delaware, the District of Columbia, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, and Wisconsin. Severe corrosion can seize the lower intermediate shaft which may cause the upper intermediate shaft to collapse and the steering column lower bearing to separate.
Potential Consequence
If the lower bearing separates, the vehicle may experience a loss of steering, increasing the risk of a crash.
Remedy
Ford will notify owners and dealers will replace the lower intermediate shaft, free of charge. The upper intermediate shaft and steering column lower bearing will be inspected to identify any damage that may have occurred as a result of lower intermediate shaft corrosion, and repaired or replaced as necessary. If the steering column lower bearing has separated, a retainer clip will be installed. The recall began on October 23, 2013. Owners may contact Ford at 1-866-436-7332. Ford's recall number is 13S08.
Steering
Summary
On certain vehicles originally sold or currently registered in areas of heavy road salt usage during winter months (Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island, and Newfoundland & Labrador), the steering column lower intermediate shaft can become severely corroded. This could cause the swing link joint to become stiff or seized. As a result, the upper intermediate shaft could collapse, allowing the steering column lower bearing to separate, causing a loss of steering capability. A loss of steering control could result in a crash causing property damage and/or personal injury. Correction: Dealers will replace the steering lower intermediate shaft. The upper intermediate shaft and steering column lower bearing will be inspected and, if necessary, repaired or replaced. If the steering column lower bearing has separated, a retainer clip will be installed.
Brakes
Summary
Certain vehicles may have brake lines that are incorrectly connected at the ABS hydraulic control unit. This would cause brake pressure to be applied to the right front wheel that would normally be intended for the right rear wheel and vice versa. As a result, braking performance would be adversely affected, including the potential for increased stopping distances that could result in a crash causing injury or death. Correction: Dealers will reroute affected brake lines.
SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:CONTROL UNIT/MODULE
Summary
CERTAIN PASSENGER VEHICLES EQUIPPED WITH ANTILOCK BRAKE SYSTEMS (ABS) FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 135, "PASSENGER CAR BRAKE SYSTEMS." THE FRONT AND REAR RIGHT SIDE BRAKE LINES MAY BE REVERSED AT THE ABS HYDRAULIC CONTROL UNIT.
Potential Consequence
THE BRAKES MAY NOT OPERATE AS INTENDED, WHICH COULD RESULT IN A CRASH.
Remedy
DEALERS WILL INSPECT THE BRAKE LINE CONNECTIONS AND THE HYDRAULIC CONTROL UNIT AND REPOSITION THEM FREE OF CHARGE. THE RECALLBEGAN ON APRIL 27, 2007. OWNERS MAY CONTACT FORD AT 1-800-392-3673.
VISIBILITY:WINDSHIELD
Summary
CERTAIN PASSENGER VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 212, 'WINDSHIELD MOUNTING.' THE WINDSHIELD MAY NOT BE PROPERLY SECURED TO THE VEHICLE BODY.
Potential Consequence
IF THE WINDSHIELD IS NOT PROPERLY RETAINED TO THE VEHICLE, WIND NOISE, SQUEAK/RATTLES AND/OR WATER LEAKS MAY OCCUR. ALSO, LOSS OF WINDSHIELD RETENTION MAY REDUCE OCCUPANT PROTECTION IN THE EVENT OF A CRASH.
Remedy
DEALERS WILL REPLACE THE WINDSHIELD FREE OF CHARGE. THE RECALL BEGAN ON NOVEMBER 22, 2006. OWNERS MAY CONTACT FORD AT 1-800-392-3673.
Generated by Cardog • December 10, 2025
2007 Ford Crown Victoria
Safety Recalls & Notices
7 Active Recalls
Requires attention
