National Highway Traffic Safety Administration1996 Dodge CaravanPowertrain › Driveshaft
The left driveshaft interconnecting shaft on my 1996 caravan sheared at the outer edge of the damper weight
ODI Happened July 14, 2001Filed August 19, 2001
In the owner's words
The left driveshaft interconnecting shaft on my 1996 caravan sheared at the outer edge of the damper weight. I was driving with my family, was stopped at a red light, and heard and felt a loud thump when I attempted to move the car when the light turned green. The car would not move. I looked under the car and saw that the left driveshaft (axle) was sheared. The car was towed and repaired at a dodge dealer. I could not get a satisfactory explanation from the service department as to why this had happened. I have kept the damaged part. The "tuned damper weight" which encircles the "interconnecting shaft" at about midpoint on the shaft had rusted and rotted out (etched) the circumference of the shaft, weakening the shaft and creating a stress fracture point which will shear under normal stress loads. The shaft is 27mm in diameter where it is not corroded, but at the cross-section where it sheared at the outer edge of the rubber cover of the damper weight, the shaft is corroded down to 21mm, more than a 22% reduction in shaft diameter! Apparently the metal used in the damper weight is subject to severe rusting, and the rubber cover around the weight traps moisture. Note: the tripod and cv joints are not damaged; the driveshaft assembly is literally broken in half. If this had happened while we were in motion we could have been injured or killed, particularily if I had been driving on the highway or making a turn with oncoming traffic. This is a serious safety issue. Because it is caused by corrosion over time weakening the driveshaft, I am very concerned that driveshafts of this design (or lots using this combination of materials) will be breaking more and more frequently (approximately 6 years before failure?), causing accidents, injuries, and deaths.*ak
An owner's report to NHTSA. NHTSA reads every complaint to decide what to investigate; it doesn't verify them, and a complaint is not a recall.