National Highway Traffic Safety Administration1990 Toyota CamryStructure › Doors

Door lock mechanism stuck when attempting to open door using handle from inside while lock button was down

ODI Happened June 6, 2001Filed August 9, 2001

In the owner's words

Door lock mechanism stuck when attempting to open door using handle from inside while lock button was down. After sticking, lock button could not be moved manually, with the power lock switch, or with the key from the outside. Driver was locked in. Cause was determined to be sticking linkage that overpowered the return spring. Lubrication solved the problem (for the time being), but not until after the door was dismantled. Poor design leaves a small spring to overcome any linkage friction caused by wear, dirt buildup, corrosion, lack of lubrication, etc. After problem was diagnosed, sticking situation could be created on demand by simply pulling the inside door handle when the lock knob was down. Sticking linkage was very consistant. In my opinion, this represents a serious safety issue, as the possibility exists for the driver to try to open the door without first unlocking it in an emergency situation and being locked in the car with no recourse. This problem is worsened by the fact that the identical failure occurred independently in the passenger side locking mechanism less than a week after it occurred on the driver side. Both linkages stuck in the same spot and both were repeatable. This indicates to me that there's a design problem that reveals itself as the mechanism ages and wears, and it seems to me to be something that should be looked into for the safety of the driver and passenger in emergency situations, especially those involving loss of power which would prohibit exit through the power windows.

An owner's report to NHTSA. NHTSA reads every complaint to decide what to investigate; it doesn't verify them, and a complaint is not a recall.