National Highway Traffic Safety Administration2018 Honda AccordElectrical, Engine, Fuel system
While driving on a bridge at under 20 mph, the vehicle's head gasket failed, causing the engine to overheat and coolant to leak from within the engine
ODI Happened August 22, 2026Filed August 31, 2026
In the owner's words
While driving on a bridge at under 20 mph, the vehicle's head gasket failed, causing the engine to overheat and coolant to leak from within the engine. The vehicle threw diagnostic trouble code P2601 and immediately entered "limp mode," severely cutting engine power and vehicle speed. Because this happened on a bridge with no shoulder to safely pull over, the sudden loss of power created a serious safety hazard — the vehicle could not maintain a safe speed or keep pace with surrounding traffic, increasing the risk of being struck by other vehicles. The vehicle was taken to a Tampa Honda (11000 N Florida Ave), where the failure was confirmed to be a blown head gasket that allowed coolant to leak into the engine cylinders. The head gasket and related components were replaced at a cost of approximately $5,000 to restore the vehicle to safe operating condition. The failed component is no longer available for inspection in its failed state, as replacement was required to make the vehicle drivable. No dealer, manufacturer representative, police officer, or insurance adjuster has inspected the vehicle; only at Tampa Honda facility that performed the repair diagnosed and confirmed the head gasket failure. Prior to this incident, no warning lamps or symptoms were noted — the P2601 code and limp mode activation occurred simultaneously with the sudden overheating and coolant loss, with no advance warning. This failure is consistent with a widely reported defect pattern among Honda vehicles with similar engines, where the head gasket fails prematurely and allows coolant to enter the cylinders. Honda has not issued a recall or acknowledged a manufacturing defect despite numerous consumer reports describing the same failure mode.
An owner's report to NHTSA. NHTSA reads every complaint to decide what to investigate; it doesn't verify them, and a complaint is not a recall.