National Highway Traffic Safety Administration2014 Ford F-150Brakes
On July 30, 2026, while operating my 2014 F-150 under normal driving conditions, the dash cluster information screen displayed a "Brake Fluid Level Low" warn…
ODI Happened July 30, 2026Filed August 20, 2026
In the owner's words
On July 30, 2026, while operating my 2014 F-150 under normal driving conditions, the dash cluster information screen displayed a "Brake Fluid Level Low" warning. Moments later, the brake system experienced a sudden/catastrophic loss of front braking performance. The brake pedal became severely spongy and traveled completely to the floorboard, requiring drastically increased distance to bring the vehicle to a stop. Due to ineffective braking, I missed the driveway of the parking lot I chose to inspect/determine what the issue was and subsequently could not stop the truck within the confines of the parking space. This brake failure put me, my family as well as oncoming traffic and pedestrians in jeopardy of injury or death due to collision. A mechanical inspection of the vehicle revealed the rear cup seal inside the brake master cylinder had failed. This internal seal failure allowed hydraulic brake fluid to bypass the cylinder and leak directly into the vacuum brake booster, completely contaminating the booster assembly. Without effective braking, the truck was deemed too dangerous to drive so it was parked and unused until replacement parts could be installed. This specific component failure, internal seal degradation, and resultant fluid contamination of the booster is identical to the safety defect detailed in NHTSA Campaign #16V345000 (Ford Recall #16S24). However, this specific vehicle was excluded from that safety campaign solely because it is equipped with the 6.2L V8 engine, rather than the recalled 3.5L engine, this despite using the identical Hitachi master cylinder. The Ford Corporate Consumer Relations was unwilling to assist with the purchase of replacement of the master cylinder, booster but did offer to record my complaint and issue a case number for engineering review. The defective master cylinder and contaminated booster assembly have been retained for inspection if required or requested.
An owner's report to NHTSA. NHTSA reads every complaint to decide what to investigate; it doesn't verify them, and a complaint is not a recall.